Question about Lincoln LS

1 Answer

2005 Lincoln Ls 3rd Brake Light Wiring

What is the best route for wiring a spoiler 3rd brake light to the oem 3rd brake light

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

The best way to wire a third brake light is to run the wire directly from the brake light switch on the side of the steering colum to the light. You will need a test light to find out what wire lights up when you push the brake pedal. Then you can splice into it when you run your wire to the rear light.

Posted on Jan 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is fuse box for third brake light and what fuse is it?


where is located brake light fuse on a Lincoln ls 2000

Sep 15, 2014 | Cars & Trucks

1 Answer

Infiniti


Did you check the fuse to see if it blew? If it did check our wiring!

Aug 12, 2012 | 2007 Infiniti G35 Sedan Sport Sedan

1 Answer

I have a 2007 Infiniti G35s sedan. I installed an OEM spoiler & spliced the spoiler wires to the 3rd brake light wires. Non of the brake lights work now including the 3rd & spoiler. What did I do?!...


Sounds like you have lost ground somewhere along the way. might try running a ground from spoiler to frame or simply replacing wires back to original and trying again. Would put my money on a ground wire. good luck

Aug 12, 2012 | Cars & Trucks

1 Answer

My brake lights on the spoiler of my 2004 Lincoln LS do not work.


lift the car and lock inside of the spoiler turn the conector and pull out the light bulb and instal the new bulb light

Jul 22, 2012 | 2004 Lincoln LS

2 Answers

Center brake light working but neither tail light brakes working both bulbs good


the center and brake light are not on the same circuit, check voltage coming from the switch

Mar 28, 2011 | 2001 Dodge Durango

1 Answer

How to replace 3rd brake light on 2004 Chrysler Pacifica?


the 3rd brake light is mounted to the spoiler. you need to remove the spoiler from the liftgate to acces the mounting bolts and the wire clip. there are five points of attachment of the spoiler,four hex nuts (metric) and one snap clip. two are accessable when the liftgate is open, they are in the corners of the liftgate. two more are under the upper rear window interior trim. the interior trim is held on by snap clips. if you pry outward on the trim starting on the right side of the window and work your way toward the middle you will be able to gain access to the two other nuts. once you have removed all four nuts, then close the liftgate and remove the spoiler by lifting up to disengage the last attachment point (snap clip). you will then need to change the light by removing the two nuts and disconnecting the wire clip. re-instal is the opposite of above. make sure that the wire for the third brake light does not get pinched when installed. (mine was improperly installed from the factory and the wire was pinched and this may have been why there was an early failure of the light)

Feb 18, 2010 | 2004 Chrysler Pacifica

1 Answer

How do I replace Brake light switch?


Make sure the switch is the culprit. Do the other taillights work when braking? if so, look for a problem elsewhere, such as wiring to the 3rd light. Give special attention where the cable is routed through the trunk lid.

Dec 06, 2009 | 1995 Chevrolet Camaro

1 Answer

My 1995 Lumina LS 3.4L DOHC third brake light works, but not the main two. Everything else works fine.(turn signals and lights)


THE TWO SIDE BRAKES LIGHTS RUN WIRING THROUGHT HE TURN SIGNAL SWITCH.WITH THE 3RD BRAKE LIGHT WORKING THE BRAKE LIGHT SWITCH IS WORKING.99.9% SURE THE T/S SWITCH IS BAD

May 14, 2009 | 1995 Chevrolet Lumina

3 Answers

Can't get the spoiler, that holds the 3rd brake light on the off


regarding chevy equinox spoiler there are three 10mm bolts one on each end and one in the middle then there are three pins in the middle that snap in. these are very difficult to release without breaking them. If they break use a two part adhesive sparingly to hold the spoiler down or it will hit when you open the hatch.

Apr 05, 2009 | 2005 Chevrolet Equinox

1 Answer

How do I change the bulb 2004 infiniti high mount bake light?


Unfortunately, these are not very simple. If you have a factory high mount brake light-meaning not one in a spoiler, you have to remove the rear seats, the rear parcel shelf and then the 3rd brake light. the 3rd brake light I believe is an LED setup which get replaced as an assembly which inserts into the housing. If you need further guidance let me know.

Thanks,

Brian

Dec 10, 2008 | 2005 Infiniti G35

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

474 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...