Question about 1998 Volkswagen Passat

1 Answer

Heater works, not blower.

Fuse ok. What do I check next and how. New at this.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Chech the blower motor to see if its working. Unplug the wire harnes and run a jumper wire to the blower motor. you will need two wires, one hot, one negitave. Put the + on on termal and the - on the other termal. make sure the wires do not touch each other and see if the fan motor will turn. If not, the motor is bad and has to be replaced.

Posted on Jan 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will not start. Fuel pressure ok, new plugs and wires. Turns over, wont start. What to check next?


Check for spark at 1 or more plug wires. If no spark, possible crank sensor/computer/fuse/wiring. Check for injector pulse. Remove 1 injector harness and install test light between the two terminals of the harness and crank engine. Test light should flash if computer/wiring ok. Make sure check engine light comes on when key in on position for bulb check. If no light, look for blown ECM fuse/s

Oct 18, 2015 | 2004 Chevrolet Chevrolet Tahoe Z71

2 Answers

Rear foglight not working bulb is ok.


Check fuse box for broken fuse or check for a loose wire on light,

Mar 30, 2015 | 2005 Renault Modus 1.5

1 Answer

Passenger side brake lights out new bulbs and fuse intact. Not sure what the problem is. What would I check next


check for voltage with a test light if none check for bad connection or broken cable, if ok check light body for bad earth connection.

Mar 13, 2015 | Cars & Trucks

3 Answers

1996 ford ranger wipers wont work fuse ok,new wiper motor,new switch, new relays. what else is there?


Do you have int wipers? If so check the int module its under the dash right side of the steering column I believe. Specifically check the solder joints.

Jun 14, 2014 | 1995 Ford Ranger Supercab

1 Answer

2001 ford windstar .Digital warning check right head light. bulb ok fuse ok what next


You say the bulb is good did you swap it you say the fuse is good is there power to it and out from it if the power is good check the ground wire if it oms out then take a multi meter put it on 12 volts DC Or more and start poking the wire until you get voltage there is the brake in the wire fix the broken wire

Apr 21, 2014 | 2001 Ford Windstar

1 Answer

How do i check to see if the fuse went out for my heat


Do you want to know why the blower doesn't work? If so, start at the underhood junction block and check the 30A BLO MOT maxi fuse which feeds power to the blower control module. Next, at the instrument panel junction block, check the 10A CSTR/SBM fuse and the 10A HVAC fuse. Both of these supply power to the heater and A/C programmer and the HVAC fuse also supplies power to the heater & A/C control. If all fuses are OK and everything is operating except the blower motor, check the voltage across its BLK and RD leads. The blower motor may be no good

Oct 27, 2012 | 1998 Buick Park Avenue

1 Answer

Brake light does not go on, fuse ok new bulbs stil no brake light when brakes are applied


check both fuse boxs if ok check the break light switch on stearing colum may be unpluged or bad

Jan 29, 2012 | 2000 GMC Sierra

2 Answers

The heater fan quit working on my 99 chevy suburban today. Any ideas on how to get it working.


KEY ON, FAN ON HIGH TAP FAN MOTOR NEAR WHERE POWER GOES IN, IF BLOWER RUNS REPLACE BLOWER MOTOR.

Jan 28, 2011 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

Heater does not work


Check heater fuse.
If fuse good - could be a failure of the blower fan motor or blower control switch.
If fuse bad - bad blower fan motor could have blown the fuse.
DO: check fuse, then blower motor.
Pricing: new blower motor: Duralast PM270 $43.99
new heater control switch: Duralast SW229 $46.99 (without
A/C).
I'd expect your blower resistor to be good - when they fail, the blower only will work on HIGH setting.

Oct 23, 2010 | 1993 Dodge Caravan

2 Answers

Driver side power window doesnt work


Its possible, check underhood fuse box, the position 6, 60AMP for Power Windows

Other details can find in the Ford-Explorer-Owners-Manual (page 187 and next)

If the fuse is OK, take off the trim panel to check the windows motor, windows switch and wires.

Hope helps (remember rated this).



Jul 23, 2010 | 2003 Ford Explorer

Not finding what you are looking for?

Open Questions:

See all 1998 Volkswagen Passat Questions

1998 Volkswagen Passat Logo

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

yadayada
yadayada

Level 3 Expert

77186 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8737 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...