Question about 1998 GMC Sierra
>>>>FIRST disable the air bag system
You'll need to remove the upper and lower steering column covers.
Also all the trim under the drivers side, kneee bolster, etc...
The ignition switch has 2 screws holding it on.
Remove those screws and all related wiring harness.
Then the switch.
Here is the procedure from GM......
Place the multifunction lever in the center or the OFF position.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Disconnect the battery negative cable.
Disable the SIR system.
Remove the steering wheel inflator module.
Remove the horn plunger contact.
Remove the steering wheel.
Remove the tilt wheel lever.
Remove the ignition lock cylinder. Remove the upper steering column trim cover.
Couldnt find a diagram. Hope this helps.
Posted on Jan 02, 2009
Tips for a great answer:
Apr 19, 2014 | GMC Jimmy Cars & Trucks
Oct 24, 2012 | Cars & Trucks
Sep 05, 2011 | 1983 GMC S-15 Pickup
Feb 25, 2011 | Chevrolet Blazer Cars & Trucks
Jan 22, 2011 | GMC Sierra 1500 Cars & Trucks
Apr 18, 2010 | GMC Sierra 2500 Cars & Trucks
Feb 21, 2010 | 1997 GMC Sierra K2500
May 10, 2009 | 1998 Chevrolet S-10 Pickup
3,062 people viewed this question
Usually answered in minutes!