- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Define "STUCK"! can you hear a sound comming from the door when you push the window button "like its trying to work but cant" ?? then yes it is truly "stuck" but, is no noise, then check out the window switch in the drivers door, it may be bad. now if it is "stuck" then, remove the door pannel and see what is wrong, could be several different types of probles inside the door that could cause this problem.. most of the time you can simply spray WD-40 on some of the moving parts in the door, then gentally convince the window to move. caution, be very carefull not to have your hands or fingers inside the door while trying to operate the windoww up or down...... you could get hurt if things got moving. The other problem could be that the indow motor has failed. same thing,, take off door pannel and replace window drive motor, it will have the "regulator built on to it". so replace complete unit. Have the manual on this jimmy will help! Hope this helps! Good Luck!
Inspect or replace the window lock and unlock switch on the drivers door power window switch. There is a lock and unlock switch that will disable the switches to the other power window in the Jimmy. Check to make sure that switch is in the unlock position to have the other power window switch to work.
Thank you for suing fixya and good luck.
You need to take inside door panel off This just clips on but there are screws in armrest and inside door handle look for any other small square covers that may hide screws Lift panel up Make sure window is up Disconnect wiring from panel and you can now get at door handle linkage and bolts
The same thing happened to my 1999 JMC Jimmy recently. I believe the problem is that your power window motor has most likely gone out or is starting to go out. The motor will need replaced. They are pretty expensive new. I went to a junkyard and got one for around 15 dollars. When mine went bad, I had rolled my window down about three or four inches and it stuck there. I took my door panel off and tapped on the motor while holding up on the window switch and got it to go up after a few minutes. I am replacing my motor today, I'll leave an update here about the outcome when I finish the job. I hope this information helps you.