Question about 2001 Plymouth Neon

2 Answers

Alternator belt I need to know where my alternator belt is located on a 2001 plymouth neon 4 cyl

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Take off you passenger tire and crawl under and you will be looking right at it

Posted on Mar 26, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 328 Answers

The altenator belt in on the passenger side of the engine beside the passenger inner fender
thanks for choosing FIX YA !

Posted on Dec 31, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to I change the timing belt on a 2001 Plymouth neon

Amy, to help you ,you need to help us here ,1-year,2-make,3-model,4-motor size

Sep 20, 2014 | 2001 Plymouth Neon

1 Answer

Where is the crank senor on my 2001 Plymouth neon,?

The crankshaft position sensor is located on the engine block behind the alternator and just above the oil filter. It is mounted with one bolt.

Aug 20, 2014 | Cars & Trucks

1 Answer

Battery light comes on in rain while idle

Your alternator belt may be loose.

Oct 19, 2012 | 2001 Plymouth Neon

1 Answer

What is a coolant temp sensor on a 2001 plymouth neon

the coolant temp sensor lets the cpu know when to turn on the fans when the coolant temp is high. It also shows the temp on the gauge in the car. I also have seen where if they go bad they will make the car run funny. It is located on the drive side in the cyl head on neons

Nov 10, 2010 | 2001 Dodge Neon

2 Answers

After driving one block the battery light comes on


Aug 06, 2010 | 1996 Plymouth Neon

1 Answer

How do you take the alternator off for a 96 plymouth neon

For REMOVAL & INSTALLATION check this procedure...
  1. Disconnect the negative battery cable.
  1. Loosen, but do not remove the alternator adjusting nut.
  1. Turn the front wheels completely to the right, then raise and safely support the vehicle.
  2. Unfasten the retainers, then remove the plastic lower splash shield.
  1. Unfasten the alternator field circuit wiring connector. You must squeeze the locking tab to release it.
  1. Remove the B+ terminal nut and wire.
  1. Loosen the alternator pivot bolt, but do not remove it.
  1. Remove the alternator drive belt. The alternator spill shield does not have to be removed.
  1. If necessary, remove the bottom pivot bolt and anti-rotation tab.
  1. Unfasten the three mounting pivot bracket bolts, then remove the pivot bolt and bracket.
  2. Holding the alternator in one hand, remove the adjustment nut then slide the alternator off the T-bolt. The T-bolt does not have to be removed. Lower the alternator and remove through the wheel well.
To install:
  1. You may need to use a C-clamp to drive the sleeve into the mounting ear for installation clearance.
  2. Position the alternator in the vehicle, sliding it onto the T-bolt. Install the adjusting nut.
  3. Install the bracket and pivot bolt, then install the three mounting pivot bracket bolts. Tighten the bolts to 40 ft. lbs. (54 Nm).
  4. If removed, install the anti-rotation tab and bottom pivot bolt hand-tight.
  5. Install the alternator drive belt.
  6. Tighten the alternator pivot bolt to 40 ft. lbs. (54 Nm).
  7. Install the B+ terminal wire and nut. Tighten the nut to 75 inch lbs. (9 Nm).
  8. Attach the alternator field circuit wiring connector, making sure the locking tabs are engaged.
  9. Install the splash shield, then carefully lower the vehicle.
  10. Tighten the adjusting nut.
  11. Connect the negative battery cable. Adjust the alternator belt.

Hope helps.

Jul 16, 2010 | 1996 Plymouth Neon

2 Answers

I just need to know where the alternator is located on a 2004 dodge neon 2.0L SXT

Fig. View of the alternator after removing the splash shield - 2.0L engines


Removal & Install - 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Alternator jam nut, loosen only Alternator adjustment nut, loosen only Accessory drive splash shield Alternator lower bolt, loosen only Alternator drive belt Alternator field circuit wiring connector, push the RED locking tab to release Battery positive terminal Upper and lower bolts, move alternator off pivot bracket Pivot bracket Alternator

To install:
Install or connect the following:
Alternator Pivot bracket and torque the bolts to 40 ft. lbs. (54 Nm) Alternator, move it onto pivot bracket Alternator field circuit wiring connector, push RED locking tab in until it snaps in place Battery positive terminal Alternator drive belt Tension the drive belt to 100 lbs. (used) or 135 lbs. (new) Alternator adjustment bolt Alternator jam nut and torque nut to 40 ft. lbs. (54 Nm) Alternator mount bolts and torque the bolts to 40 ft. lbs. (54 Nm) Accessory drive splash shield
Negative battery cable

Fig. Alternator mounting-2.4L engine shown


I hope helps with this (remember rated this help) Good luck.

Jan 05, 2010 | 2004 Dodge Neon

2 Answers

Broken Belt under the 1998 Plymouth Breeze 2.4L DOHC 4 Cyl. engine.

Sounds like you have a broken belt that drives the alternator, water pump and maybe the power steering depending on engine type and size. Have the belt replaced before driving car as if you overheat the engine you could end up with major engine damage.The belt on the 2.4 litre engine is manually adjusted with a bolt on the alternator housing. To install this belt yourself maybe difficult if you do not know the routing of the belt around the number of pulleys involved. get help.

May 24, 2009 | 1998 Plymouth Breeze

1 Answer

Replace alternator for a Plymoth NEON

the alternator for a 95 neon

1 first take the right tire off
2 then lift the car
3 then get a 15mm socket and loosen the blots of the bracket
4 then open the hood and undo the power steering and take off the top bot of the alternator
5 then take off the bottom blots and take off the bracket
6 then move the alternator so you can disconnect the wiring i think you need a 10mm for that maybe smaller
7 then pull it out(when i did it to mine it was hard to pull it out)
8 then to put it back just the same way but backwards

mine broke too if you need more help email me ozark99@hotmail .com

Mar 28, 2009 | 1995 Plymouth Neon

Not finding what you are looking for?
2001 Plymouth Neon Logo

Related Topics:

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

74269 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7234 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides