Question about 2000 Hyundai Accent

1 Answer

Passenger side power window wiring harness

I am replacing the power window switch on the passenger side. i have the harness, but the wires were pulled from the correct slots. i need to know whichwires go where on the 8 slot harness. my wires are blue, orange, gray, and 2 green

Posted by on

  • MHOSS Jan 04, 2009

    EXACT SAME PROBLEM NEED HELP

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 21,949 Answers

Go to scrapyard and have a look on one in their??

Posted on Jan 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is window fuse?


according to my info, you don't have a fuse, you have a power window circuit breaker.
I would begin by testing the wire harness on hinge side of driver door. If protective rubber boot covering, see if you can pull boot back far enough to see wire colors. Pink wire is voltage for power windows. That goes hot with the key on. Black wire is ground. If good voltage and ground, the problem is in the door, wiring circuit--master switch or window motor.
Some relays may be located passenger side kick panel near floor. Sorry, I don't have exact location for that relay.

Dec 18, 2015 | 1992 Pontiac Trans Sport

1 Answer

2002 Carvan Driver side window switches (both) all of sudden do not work.


ck the wire harness in the drivers door jam ,you will have to pull back the rubber boot sometimes the wires brake there from repeted open and closeing of the door,if there ok ck. for power at the motor when operating the switch

Mar 22, 2014 | 2002 Dodge Caravan

1 Answer

Car window


inside the door panel is the motor for the window check for power at the wiring harness and then check for power to the switch and then trace the wires to the motor if there is power to the wires the motor is bad for the window

Jun 03, 2013 | Cars & Trucks

1 Answer

I have a 1994 Toyota Camry and the power window on the passenger side has gone down, under power. Then nothing would happen when I would pulled up on the switch on the driver side main switch and the also...


more than likely one of the switches are bad (down side of switch works but up side of switch dont) being as the switches are wired together if one goes bad other one won't work either take the switch out one of back doors should be same as front passenger door put rear switch in front passenger door if works then u know front door switch is bad if it doesn't then drivers door switch is bad
u replaced window regulator Did that come with motor too??? if not check to see if motor is good
there is two wires going to motor cut isolation back on wires and using some jumper wires attach one wire to positive terminal of a 12 volt battery attach other wire to negative terminal of battery window should move up or down reverse connections and window should move other way

Jan 29, 2011 | 1994 Toyota Camry

4 Answers

Window problem


Might want to check the doors with the problem windows for a broken wire from the door to the door jam.

The window lock switch is a single circuit to all the other windows, so if there was a problem with it, none of the window controls would work ( but the driver's side would still operate them ).

The other place to check for a broken wire is the driver's side door to a-pillar harness. The circuits for the other windows run through the driver's side switch. Could be a wire in the driver's side door harness.

The other item could be the driver's side switch, the contacts will get carbon built up on them, and the windows will not operate anymore.
This is what mine looked like when the driver's side window stopped working ( lower left hand corner of the picture is the driver's side window switch, note the carbon build up on the contacts )
ccfb7fb.jpg

I would start with checking for broken wires, by metering the window switch for power.

The back passenger's window switch should be getting power & ground on the white w/ yellow stripe wire and the tan w/ light blue stripe wire.
in the "at rest" position on the driver's side switch, these are supplying ground to the power window, and power is being applied to the other side of the motor ( depending on direction of travel ).
792a56e.jpg

Apr 05, 2010 | 2004 Ford F150

2 Answers

How to replace passenger side mirror on 2007 Camry


To remove mirror pry off inside triangle panel(black) which exposes 3 nuts which are removed with socket wrench. Detach wire harness and pull out mirror assembly. To replace insert new mirror screws thru assigned holes and reconnect wire harness and tighten nuts to snug. Push inside triangle panel back into place and you're done! It's that easy.

Dec 04, 2009 | 2007 Toyota Camry

3 Answers

03 Chevy Venture....Clarification Passenger Window stuck down.


It will be in the switch lift up the controls on both the drivers side and passenger side the wires going into the connection wiggle then and the button at the same time if you get any movement then you have a broken wire if not use a test light hook one wire to some metal and the other to the wires if their is any power the light will come on, if no light then you probably have a broken wire. The passenger side power comes from the drivers side control. When you open the doors you will see a large black set of wiring harness in the door going into the side under the dash that is the wiring harness for all the power windows and door locks, open it and test those wires for power.

Aug 04, 2009 | 2003 Chevrolet Venture Passanger

4 Answers

2004 saturn ion driver power windows switch will not work. Fuse good and passenger window switch works. The switch unit is good had a new on put on still did now work. Problems seems to be in wiring after...


Pull the rubber boot for the wiring harness in the door hinge area. I would suspect cut wires. Have the same issue. Bad design. What else is new.

Jun 12, 2009 | 2004 Saturn ION

3 Answers

Driver side power window stops working in 2003 mits. eclipse


the switches need cleaning ,they have contacts in them that get dirty you can spray contact cleaner on them or use emery paper to file them, they are not to hard to pull apart

Jan 16, 2009 | 2001 Mitsubishi Eclipse

1 Answer

Failed power window


I'd bet on a broken wire in the harness going to the drivers door. I suggest the drivers door because it is used the most often. You can pull the master switch and check the wires for continuity to the harness just under the dash at the fuse box, after removing the lower dash trim panel. Sometimes you can gently pull on the wires of the door harness from under the dash and one will pull right out. Thats how I found mine.

Jul 08, 2008 | 1992 Toyota Camry V6

Not finding what you are looking for?
2000 Hyundai Accent Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...