Question about 1999 Chevrolet Lumina

1 Answer

Head light I can not figure out how to change the head light bulb on the passenger side of my 1999 lumina

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 120 Answers

Get under the car reach behind the bumper reach towards the blinker then find the wire that goes to it. Then twist the end left and pull out the light bulb in and and replace. For the headlight blinker you have to unscrew the headlight with either a 10 or 13mm socket...pull it out...then twist the end that goes into the blinker left...replace bulb....put things back together....done.

Posted on Dec 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change head light bulb, drivers side, 2006 Saab 9-7X


Easiest way is to stick your hand in front of the battery and take the dust cover off, twist the bulb and done. I'm lucky, have smaller hands! lol, If you can't get to it, remove the battery for easy access.
The passenger side requires removal of the aircleaner box.

Mar 25, 2015 | 2006 Saab 9-7X

1 Answer

How do I change a head light on a 1999 lumina


If you just need to change the headlamp bulb, your owners manual has that info. If you don't have an owners manual go to my.gm.com

Type in year--make--model, hit go, click on owners manual/guide, click on pdf file.

If you want to remove headlamp assembly, let me know and I'll post the procedure. I wasn't sure if you just needed to remove bulb or the whole lamp assembly? Don't touch the new bulb with bare hands/fingers, use gloves.

Feb 20, 2015 | 1999 Chevrolet Lumina

1 Answer

Turn signal and break light


Make sure all the bulbs are working in the turn signal. Some front turn signals will use two or more bulbs per side. If any one of these bulbs are burned out it will cause the turn signal to flash at a fast rate. It also could be a bad control lighting control switch a.k.a. multi-function switch.

Mar 17, 2014 | 1999 Chevrolet Lumina

1 Answer

Drivers side head light is way dimmer than passenager light even after new bulb replacement


When looking from the outside of the headlight at the bulb, can you see the bulb clearly??
These lenses are notorious for dulling very badly. If it has you can use a regular headlight 'restoring' kit sold at most auto part locations.

If it is not a lens issue, you may have a wiring/supply issue.
Then you would need to find the troublesome wire/connection.
I am not the best at wiring issues, but I would try to find a power source wire with the same amperage rating, run a bypass jumper from a known good voltage source and see if the light changes. If no change, your problem may be the harness or plug at the rear of the headlight bulb.
Hope I could help
GL

Dec 31, 2011 | 1999 Plymouth Voyager

1 Answer

My passenger head light went dim and i changed it to a brand new bulb already and it is still low


You got a bad ground connection somewhere.
You have a voltage drop,where you shouldn't have,and as a result the bulb is dim.
Check the bulb socket/connector and related wiring, to that head light

May 21, 2010 | Cars & Trucks

1 Answer

How do you replace the corner light bulb on the passenger side of a 1999 toyota solara?


You need to remove the head light assembly,the marker light can be accessed then.

Jan 23, 2010 | 1999 Toyota Camry Solara

1 Answer

How to change headlight bulb 2006 chevy trailblazer


See note below for passenger side. Remove the dust cover on the back of the head light assembly (black round rubber cover about 3" in diameter, just pull it off), disconnect the plug on the bulb, turn the bulb a 1/8 turn and pull it out. Then reverse the process for assembly.

***NOTE***If you are trying to replace one of the bulbs on the passenger side, remove the air filter housing cover and displace the filter for access to the dust covers on the back of the head light. 2 screws hold the air filter housing cover on, one directly behind it and one on the side (drivers side of air filter housing).

Jan 03, 2010 | 2006 Chevrolet Trailblazer

1 Answer

How to replace our low beam headlight on 1999 town and country


1.) Open the hood of your van 2.) On the passenger side of the vehicle, look behind the headlight enclosure. You will see a set of wires running into the back of it. This is the power clip. Either with your hand or a flat-head screwdriver, pop the power clip off.
3.) There is a plastic ring encasing the light bulb. Turn the ring counter-clockwise and pull it out of the socket and set it aside.
4.) Pull firmly on the light bulb to remove it.
5.) Place the new light bulb into the same opening. Be careful not to touch the glass part of the new bulb. The oils in your skin can substantially reduce the life of the new bulb.
6.) Replace the plastic ring and turn it clockwise to lock it in place.
7.) Reattach the power clip to the back of the bulb.

Oct 29, 2009 | 1999 Chrysler Town & Country

Not finding what you are looking for?
1999 Chevrolet Lumina Logo

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...