Question about 1993 Oldsmobile Cutlass Supreme

1 Answer

Place thermostat is it hard to replace in 1993 cutlass surpreme 6 cy? thanks........ron

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 491 Answers

No it is not

Posted on Jan 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 1995 Oldsmobile Cutlass Ciera (4 dr, V6) make grinding noises when starting to drive? It only happens during takeoff, and sometimes while driving and accelerating hard. Just replaced cv joint...


Sounds like either the Torque convertor, going bad. Could also be the clutches in the trans. Did you replace both the inner and the outer CV joints, both side ? Also check your the outer bearing where the CY joint goes through at the wheels

Jan 09, 2015 | 1995 Oldsmobile Cutlass Ciera

1 Answer

I have a 1997 cutlass surpreme what tools do i need to change the timing chain kit?


A rally complete set of hand tools, wrench, sockets ratchets extensions all of it.

Jun 01, 2012 | 1997 Oldsmobile Cutlass Supreme

1 Answer

My 1994 olds cutlass surpreme idle at 2000 rpm .why ?


Thanks for choosing FixYa and welcome. You may need to adjust your idle. It may be set too high. If not, you could have a bad idle control sensor. This would cause your vehicle to idle high. It may be a defective map sensor. Make sure the cable is not sticking, which would cause the vehicle to idle high. It may need adjusted or replaced.

Jun 11, 2011 | Oldsmobile Cutlass Supreme Cars & Trucks

2 Answers

LMy 93 Cutlass has the 3.1L V-6. I need to replace the thermostat. Which way is the thermostat supposed to go? Spring side down, or up?


Good Evening, on your thermostat the spring goes towards the motor which is away from the hose. Hope this helps.

Oct 01, 2010 | 1993 Oldsmobile Cutlass Supreme

1 Answer

How to change a thermostat in a 1993 oldsmobile cutlass ciera


Drain some coolant from radiator to below level of thermostat housing. Be careful to keep pets away as coolant is very sweet smelling and poison. Remove two bolts holding thermostat housing in place and use catch pan to catch fluid. Clean all gasket material from both sides of housing. Clean threads of bolts and use gasket shellac on them and new gasket. Install thermostat same as old one was, install new gasket, tighten bolts to correct torque value as found in your handy dandy shop manual. Refill radiator and check for leaks.

Aug 04, 2010 | 1993 Oldsmobile Cutlass Ciera

1 Answer

I have a 1996 cutlass surpreme 3100 series and it overheats and has a leak toward the back of the engine the leak is bubbleing out antifreeze what could it be?


one of the most common problems with th 3100 is that the intake gaskets leak in the corners. You can purchase the gaskets at auto parts store. They do not cost much and are not that hard to replace. Purcase a repair manuel for about 20. dollars and there will be a step by step procedure on the fix. Hope this helps leave a comment.

Mar 26, 2010 | 1996 Oldsmobile Cutlass Supreme Coupe

1 Answer

Does it have FWD


as written by you, yes
a cutlass surpreme is rear wheel drive thay year

Feb 27, 2010 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Replace thermistat


I believe that year had the 3.1L or 3100 engine in it, (correct me if I am wrong and I'll see if any corrections to my information is needed). If that is so, then replacing the thermostat in that engine is not as straight forward as most. The reason is that the thermostat is mounted in a vertical position on the side (drivers side) of the engine and is in tight quarters because it is surrounded by the cross over exhaust pipe and boxed in by the throttle body and a few other things.

It can be done, but it is time consuming getting to it.

Dec 31, 2008 | 1993 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
1993 Oldsmobile Cutlass Supreme Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

64286 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...