How to time a 91 oldsmobike bravada - 1991 Oldsmobile Bravada

Have you tried spraying the channels the glass slides in with Silicone spray lubricant? Do that but keep it off any plastic tor trim.

Cranking & turning over are the same thing

Have you tried the local autozone store they stock some great haynes repair manuals ...cheap too.

speed sensors are @ the wheels as part of the wheel bearing

If it's off now nothing, pick up a bad signal from one of your engine sensor but fix it self, if it comes back on and stays on have computer diag. done and get back with us and will see how we can help you.

looking for blow up picture on installation of power steering pump

yes just below steering colum remove lower panel two or four screws put the car in actual neutral on right side of colum should be clip with cable remove & line needle up to middle of the N shift car to park install panel all done

Does the pointer move or is it just pointing at the wrong position. It's adjustable.

Find and check the temperature gauge sensor 'sender' unit on the engine.
To test:-
- if you ground the wire connected to the sender the gauge should go to full scale high,
- open circuit the gauge should read zero (nil deflection).
If above test ok, replace the temperature sender unit with correctly specified item.

The problem may be the switch itself. Do the arrows light up and stay on? Have you replaced the flasher itself, up above the fuse panel? And it is best for the car to have all four new bulbs put in at the same time.