Question about 1996 Nissan Pickup

Open Question

Bmw 330xi evap problem

I have a 2004 bmw 330 xi and the service engine soon light came on. when i brought it to my mechanic he plugged in the tool to see what the problem was. he said it came back with a fault code 1447 and tried to look it up. but got no answers. what is 1447? and how do i fix it?

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 73 Answers

SOURCE: service engine soon light

Sometimes if you leave your gas cap loose or you don't get it on right it can set this code. Check your gas cap and clear code with your scanner. If it comes back on you will need to take it into your dealer as it should be under warranty.

Posted on Sep 12, 2008

Ad
  • 14036 Answers

SOURCE: nissan frontier 2002 failed emissions test with

CODE PO447 EVAP CANISTER VENT CONTROL VALVE CIRCUIT OPEN.POSSIBLE CAUSES. 1.HARNESS OR CONNECTORS THE SOLENOID VALVE CIRCUIT IS OPEN OR SHORTED. 2. EVAP CANISTER VENT CONTROL SOLENOID VALVE.

Posted on Jan 07, 2010

  • 3640 Answers

SOURCE: Nissan altima 2000 with engine service light on.

p0325 is, ignition system or misfire, could be plugs, wires, or a bad coil. p1126 throttle control motor relay curcuit open.P1126 Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery voltage is provided to the ECM. When the ignition switch is turned OFF, the ECM sends an OFF signal to throttle control motor relay and battery voltage is not provided to the ECM. possible cause, Harness or connectors (Throttle control motor relay circuit is open Throttle control motor relay.

Posted on May 07, 2010

  • 7 Answers

SOURCE: po 1447 evap

See this thread:

http://www.fixya.com/cars/t7808162-code_p1447

Posted on Feb 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2006 BMW 330xi idles hight when driving?


How high? Do you have a check engine light on?

Sep 10, 2014 | 2006 BMW 330xi

1 Answer

'service engine soon' light


I think that is scan tool only but most mechanics have the scanners these days so it will be a lot cheaper to go to your local mechanic instead of the dealer. It prob wasn't reset last service if the light wasn't on at time of service.

Jul 15, 2012 | 2006 BMW 330i

1 Answer

2006 BMW 325 xi is overheating,


he first thing is a compression test to check for gasket or cracks ( any qualified mechanic will know that)
next is to check if the scan tool in use has the right protocol for bmw electronics
there are plenty of manual checks that can be done without resorting to a scan tool

Jan 27, 2018 | Cars & Trucks

1 Answer

No Service Engine Soon seen for code P0442


code p 442 refers to evaporative emission (EVAP) system---small leak detected
it also refers to large leak detected --fuel cap off/loose === causes hose/connection,-- intake leak--EVAP canister---EVAP canister purge valve --mechanical fault --- EVAP pressure sensor

Oct 17, 2017 | Mitsubishi Cars & Trucks

2 Answers

How do you reset the service engine soon light on a 2006 BMW XI. Itwent on due to a faulty gas cap which I replaced but the light stays on.


Unfortunately, BMW is a pain - in -the - **** and only a BMW dealer or an independent shop with BMW tools can reset this.

May 07, 2011 | 2003 BMW 325

1 Answer

1999 Grand Am GT ''Service Engine Soon'' light. AutoZone did a scanner, and the codes are 1. ''engine burning too rich'' 2. ''evap leak'' 3. ''engine misfire.' The light has been going off and on for the...


The Evap leak is the least of your worries right now,concentrate on the rich exhaust which sounds like there is a spark plug not firing and raw fuel is going out your exhaust system which could damage your cat.converter.Can you get the exact codes that were pulled by autozone? the P0 #s would help try to track down your problems.

Dec 21, 2009 | 1999 Pontiac Grand Am GT

1 Answer

Service engine light wont go off on my 2001 BMW 330xi how do i fix


the light is on due to a fault in the system controls of the egnine or emission control system, have the system tested for trouble codes that aare stored when ever the light is turned on by the PCM (powertrain control module)

Jun 03, 2009 | 2001 BMW 330

4 Answers

Service Engine Soon light on 2002 BMW X5


go back & sleep with the mechanic, that always works for my sister.

Jan 02, 2009 | 2007 BMW 530xi Sports Wagon

Not finding what you are looking for?
1996 Nissan Pickup Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

78238 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...