Question about 1994 Cadillac Fleetwood

1 Answer

Cad 94 Fleetwood MAP sensor location

You answered my question and suggested it could be the MAP sensor. Where do I find the MAP sensor on my 94 Fleetwood to change it?

Thanks,

Ray

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 740 Answers

Its on the intake manifold, Click on this links and see a picture of the actual sensor. http://shop.advanceautoparts.com/ProductList.aspx?parttype=414&ptset=A&searchfor=MAP-BARO+Sensor Its has a 3 pin plug and a singe vaccum hose goes to it . Good Luck Sorry I didn't get back to you sooner,thanks for using FIX YA

Posted on Dec 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is map sensor located on a 94 Cadillac DeVille 4.9 engine


Under hood, center, rear engine area, above valve cover, mounted in bracket.

From autozone.com:

Manifold Air Pressure Sensor

Fig. MAP sensor specifications-note how altitude and pressure affect the voltage readings
REMOVAL & INSTALLATION

  1. Remove the intake manifold top cover.
  2. Disconnect the crankcase breather tube from the throttle body.
  3. Remove the MAP sensor from the intake manifold.
  4. Detach the MAP sensor electrical connector.
  5. Inspect the MAP sensor grommet for wear or damage and replace as needed.
To install:
  1. Installation is the reversal of the removal procedure.

map-sensor-located-94-cadillac-deville-3yvs1abwdo3hwax2tll0gwig-1-0.jpg

Feb 14, 2016 | Cadillac Cars & Trucks

1 Answer

On a 1996 Cad. Deville, where is the tubine speed sensor located?


press the helpful button and follow me on fixya for more tips
Input speed sensor is located inside the transmission. The sensor is located next to the sprocket for the input shaft. The sensor is held in place with 2 6mm bolts, one for the sensor, one for the wiring harness.

Input Speed Sensor P0717 Replacement

P0717 ISS Speed Sensor Code Cadillac Deville Eldorado Seville Fleetwood...

Vehicle Speed Sensor Removal Installation

Feb 01, 2016 | Cars & Trucks

1 Answer

1994 jeep wrangler map sensor location on motor


I have a 94 jeep wranger just started to idle at 3000-3500 rps checked the tps and tbi no change but remove the vacuum line to map sensor idle lowers 2000 but runs rough

Jan 31, 2013 | 1994 Jeep Wrangler

1 Answer

Can i install a fuel pump from a 91 cadillac fleetwood to a 94 seville


If you can check the part numbers stamped on the two different pumps and they are the same then that answers your question.

Dec 25, 2012 | 1994 Cadillac DeVille

1 Answer

Where is the combination valve?


The combination valve is located at the brake master cylinder, it is what sends fluid to the brake cylinders. See picture of typical valve below.
2_22_2012_7_07_04_pm.jpg

Feb 22, 2012 | Cars & Trucks

2 Answers

I am trying to locate where the map sensor is on my 2006 Chevrolet express 1500 4.3 van. I need to install a new one have the part but need to know where it goes.


I don't mean to be critical, but if you do not know where the MAP Sensor is, then you could not possibly have tested the MAP Sensor circuits. If the MAP Sensor circuits have not been tested, then there is no way that anyone can be certain that your vehicle actually needs a MAP Sensor. (Many MAP Sensor codes cannot be fixed by replacing the MAP Sensor itself.) Then again, you might just get lucky.

To answer the question you asked, The MAP Sensor is located on the passenger side of the intake manifold near the rear of the engine. You must remove the doghouse to get to it.

I recommend that you also review this article: What Else Could Be Wrong?

I wish you luck!

May 09, 2011 | Chevrolet Express Cars & Trucks

1 Answer

Need to turn off my barke and abs light off that are on my dashboard for my 94 cadillac fleetwood brougham


without a scan tool and/or a DVOM you will be guessing as whats wrong

since you made no comments in tour post about physical brake issues then you are most likely dealing with a wheel speed sensor issue

however, you need the codes pulled to verify which sensors need replacing



May 07, 2010 | 1994 Cadillac Fleetwood

1 Answer

I have a cad sts 94 and the service engine light is on


MAP ( manifold air pressure ) sensor code

May 02, 2009 | 2002 Cadillac Sts

1 Answer

94 Fleetwood hesitates and dies going up a hill (12 - 15 mph)


Sounds like A MAP sensor or a bad fuel Pump. Good Luck

Dec 28, 2008 | 1994 Cadillac Fleetwood

Not finding what you are looking for?
1994 Cadillac Fleetwood Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...