Main enigine Fan doesnt work

have you tried replacing your radiator cap?

Try installing a jumper across the N/O terminal at the relay socket. Temp sensor in the radiator or in the thermostat housing supplies the signal for the relay the other relay signal is supplied by A/C in on position. both fans will run continuous with A/C on. One fan runs intermittent relative to water temp. Be careful not to blow a head gasket. If you leave the jumpers in place, the fans will stop when the ignition is turned off, save the engine until you isolate the relay signal problem. then simply remove jumpers and reinstall the relays

if the freon charge is low the system will shut off to prevent compressor damage and the pressure also turns on the fan they don't hold much so a small leak will act fast

Be sure you check engine oil level often. The low oil sensor will disable the ignition. If you turn A/C on the cooling fan should run continuous, Check the fan relays. Make sure coolant level is correct at recovery bottle, never open radiator cap. A scald hazard exist, be careful. This car is old and complicated, and is beyond your skill level to repair. Try to inquire here for advice, whenever possible. Don't throw good money at bad money

it could be a possibility that the engine is running at normal temperature but your gauges are telling you that it is running hot the only way to tell is to get a temperature gauge & connect it into the water system somehow to give you an accurate reading or take the vehicle to a radiator repairer & they may be able to do it for you..........hope this helps.....cheers.

the fan not coming on unless you turn the a/c on is a clue.this tells you the fan is working but the coolant sensor for the fan operation may not have been the one you changed(as there is one for the dash gage/light and one for the computer to turn on the fan).also the fan relay may be the problem not turning the fan on without the a/c on.

First check the 15 amp HVAC fuse located in the main fuse block inside the car on the passenger side of the center console, under a cover. If the fuse is good, then the problem may either be the HVAC blower switch (which is the fan blower selector switch), the fan blower motor resistor, or the fan blower motor. An auto repair manual will explain and illustrate for you the steps on how to check each of these components.

Even after pushing the ac light switch on, the fan blower selector switch has to be turned on as well (working) because it provides an electrical path to the positive side of the battery to complete the circuit and turn the ac light on. What the ac light switch does is provide the electrical path for the ac compressor clutch to come on through the ac control relay which is controlled by the car's PCM(computer) when you want ac, but the ac light switch still needs to run through the fan blower selector switch to receive its power. You can turn on the fan without the ac light switch because it gets its ground path(negative) from the blower motor. So the blower motor has to work in order to provide a ground path for the fan blower selector switch to be functional. You could have a faulty blower motor which is why no air blows through the vents. The fan blower motor is located inside the car on the passenger side underneath the dash at the bottom end of the glove compartment box. You'll see it. It's right above where a person rests their feet on the floor. Therefore, if your 15 amp HVAC fuse is good, check to see if you have voltage at the blower motor connector. Unclip the connector and with the ignition on and the fan blower switch moved to any one of the first 3 selections, check for voltage using a multimeter. The voltage will vary because there is a blower motor resistor. Voltage should be higher on setting 3 than 1. If you do have voltage at the blower motor connector, check for a faulty blower motor. The auto repair manual will tell you how to do it using jumper wires.

It's normal that your car is running hot because the radiator fan works in conjunction with your ac compressor. If the ac is on, the radiator fan will be on and therefore the engine coolant temperature will stay in it's normal operating range. If the ac is off, the radiator fan will stay off as well and the engine coolant temperature gauge will begin to rise and show pretty hot (especially at idle). It will do this up until a certain degree then the radiator fan should turn on thermostatically and stabilize the temperature. It's scary and I know what your saying because it does that to my car if my ac isn't on. Don't worry it won't overheat.

How did you determine that the sensor failed. Did the check engine light come on? When you say that the fan won't turn, do you mean that it won't turn on and run or that you can't physically turn it by hand. To determine this, disconnect the electrical connector to the fan and try to turn it by hand. It should turn easily. If it doesn't then it must be replaced. If it does then reconnect the electrical connector to the fan and try to operate it by disconnecting the temperature sensor lead and placing a jumper wire between the terminals of the harness. turn the AC control to AC/MAX and turn the ignition key to on. If the fan runs then the problem is the sensor. If it doesn't then check the fan control relay and any related fuses. WARNING : Use extreme caution when testing the fan circuit. Never attempt to turn the fan with the electrical connector in place. The fan can operate at any time even if the engine is off.

This can be due to a bad relay or coolant sensor that turns on the fan or a bad fan, a good test to do to see if the relay and the fan work is to start the engine and then turn on the ac, if the ac doesnt work then unplug the coolant temp sensor this will turn on the check engine light but it will reset when you restart engine, if the fan turns on then fan and relay are good and its the sensor, if the fan doesnt run then it may be the relay or fan, a quick test of the fan is to dissconnect plug to fan and run a power and ground wire to fan and if it runs then you have a bad relay,hope this helps,

Are you fully charged though? If you don't have a full charge the clutch will not kick in.