Question about 2003 Chevrolet Silverado 1500

1 Answer

2003 silvarado need help

I was wireing in a trailor plug and had my lights on for to long and had to jump it and now when i come to a stop it wants to die ive never had eny problem befor with this truck.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 948 Answers

Your battery ran low and you jump started with a low battery, putting a lot of stress on your alternator. I would pull the battery and load test it after fully charging it and also have the alternator tested.

Posted on Dec 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No plug on truck for trailor trailor has 4pin plug how do i wire 4plug to my truck99 dodge ram pickup


Depending on the power requirements of the lights on the trailer you may have to use relays.

Provide me the model #, year and motor of the truck so I can check the schematics

Apr 06, 2015 | Dodge Cars & Trucks

1 Answer

Hi,I have 2010 stralis,the handbook is written in Norwegen i think,when ihook up to trailor the near side trailor lights do not work,i cant work out which fuse i need to change,Help


when hooking up trailers ,the problems are usually in the plug connections. It is very possible that there is a broken wire in a plug or the wiring in the car is different to the plug. If the lights of the vehicle all work then it is not a fuse but in the plugs or trailer.

Jan 24, 2015 | Cars & Trucks

1 Answer

Dodge durango 1998 need wire diagram for trailor light on 98 durrango truck is not factory equipped


the colour code for the wiring is on the trailor plug if its a 4 wire green is right signal, brown is taillights, yellow Is left signal, and white is ground. on the truck. check which wires on the truck are right, left, and taillight. the ground wire you can use any ground for the light system or hard wire the ground to the body of the truck.

Aug 21, 2014 | Cars & Trucks

1 Answer

Trailor plug camry sv21


You don't need a colour code as long as you have a test lamp or a voltmeter.
Turn the side lights, indicators, stop lights, reverse lights, rear fog lights on individually and test for a positive wire each time. Label them with some paper tape and a pen if it makes it easier to keep tabs on them.
All your lighting wiring is in the back of the car/truck/hatch, whatever. Your rear light clusters will lead you to all the wiring you need. If its any help, the rear light cluster bulb positions give away which wiring leads to which bulbs. You can see the colours of the wires right there.


Good luck.

Nov 14, 2012 | Cars & Trucks

1 Answer

Chevy silvarado 2003 running rough...rep dist cap wires and plugs n rotor...running extremly rough


You have likely crossed some of the ignition wires. Recheck your firing order and wire placement.

Aug 30, 2011 | Chevrolet Silverado 1500 Cars & Trucks

2 Answers

Installed a wiring kit for a trailor but when i hit the brakes the lights go out on the trailor.any ideas?


Hi,
You need to get a proper earth connection through the trailer. Ensure all your light is earthed to the trailer on the steel parts, then take a wire from the trailer plug to the frame.
Then on the car make sure you have the same pin as for the trailer earth going to the car earth pin, then find a good earth on the car and run a wire from the car plug to that earth.
This should stop your lights from flickering when the indicator is on also. So in short wire in a good earth for the trailer as well as a good earth for the car. Hope this helps, let me know how you get on.

Apr 04, 2010 | 1995 Chevrolet Blazer

1 Answer

When i hook my trailor's lights to my 2003 yukon xl, park lights doesnt work, but all other lights work


You mean the truck parking lights dont work, or the trailer running lights dont work? Does the trailer just have tail lights or does it have front and rear side markers? I think you mean the trailer lights. Check for power at the plug,(Brown Wire) if there is power, then you could have wiring problems, but a better description of what works and what doesnt work needs defining.

Dec 18, 2009 | 2003 GMC Yukon XL

1 Answer

Hi, When I hook up my trailer, I get running


according to wiring diagram no module . do you have pwr at trailor connector. should be green w/ white wire coming into trailor connector. ( I believe pin 7 on connector ground should be pin 5 and is white with black wire )

Oct 25, 2009 | 2004 Toyota Tacoma

2 Answers

Hi, plug in in the back does not work for a hook up on my trailor. all the tail lights on the truck do work. the trailor about half of them work. i do not have tail lights or backup lights and my left...


You probably have corrosion in the socket on your truck. You'll have to take the plug in apart and check it. Or, it could be loose, damaged or broken wires leading to the plug.

Jul 10, 2009 | 1997 Ford F150 Regular Cab

2 Answers

Trailor lights not working


The trailer wiring is dud. If you getting good signal at the car it must be the trailer. steve.. uk

May 13, 2009 | 1996 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...