Abs and brake lights on is a warning that your car has some issues related to the braking system. fix it first.
you got to bring it to a dealer or certified auto technician to diagnose the problem, you need a scan tool to determine the particular problem. yes your brake shall work fine but then these abs and brake warning lights are designed for occupants safety so dont take this for granted.
ok trace your brake lines from master cylinder going to abs and lines going out of abs to the wheels, check for loose wires and dislocated valve mountings, check brake linings and pads if you still have enough, if its low, replace it, then try this.... with your ignition key in on position, remove the fuse for hazard, turn the key off, then remove negative battery terminal and let it sit for 5 minutes then connect the negative terminal and put back the fuse for hazzard. everything shall be reset including your clock and other preset radio stations, (take note of that) then try if the lights are still on with the car running. follow these instruction carefully. dont jump from one procedure to the other. good luck!
×
SOURCE: I HAVE A 2008 TOYOTA YARIS. dURING TH RECENT COLD
Anti lock brakes are disabled. you need to have the car scanned to see which ABS sensor is causing the problem. you can check all the wheels and see if the abs wire going to one of the sensors was ripped out by road debris or ice chunks. you have to look behind each wheel to do this. easier with the wheels off, just follow the wiring and inspect for problems.
SOURCE: ABS and Check Engine Lights on
This could be the case, Car computers don't like being started other than how it was suppose to be started, You will need an error code reader just to confirm there are no problems with the engine then you can clear any stored error codes which will turn off any lights you have on.
SOURCE: toyota yaris brakes how do you bleed the brakes on a toyota yaris
have someone pump the pedal and hold it, then you work from the right rear, left rear, right front, left front, while the person pumps and holds several times at each wheel.
14,006 views
Usually answered in minutes!
Hi,
friend all OK ,how do mean fix it.
I think both ok,how to switch both light.
thx
Hi,
friend we have no dealer in my country Iraq as u know sitution
therefore no dealer ,i have obd scanner error reader ,
do have another to reset if both abs and brake ok
to switch both warning ligt
Hi Merry christmas for u,
Friend I will try that today.sent u result.
Thanks
Hi,
friend I follow all that step ,still have same problem,
I want to check sensor in all wheels can tell how to test it
or measure the sensor.
Thanks
×