Question about 2004 Jeep Grand Cherokee

1 Answer

2004 jeep grand cherokee blower motor controller melted contacts

Blower motor controller contacts melted

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 116 Answers

Replace the switch and the plug end uf the harness.... do one wire at a time availabla from chrystler

Posted on Dec 31, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove heater blower motor?


1998 ATC Jeep Grand Cherokee Blower Resistor connector ...

? 0:55
www.youtube.com/watch?v=sDFLuenx9aw
Nov 14, 2012 - Uploaded by Freedomautomotive1
1998 ATC Jeep Grand Cherokee Blower Resistor connector Repair Kit (RARE 1/2 Year) ... How to Fix a Chrysler Blower FanThat Only Works on High - Duration: 16:51. ... JEEP2001 FIXING THE HEATER BLOWER CONTROL. ... Jeep Grand CherokeeCenter and Lower Dash Removal - Auto Repair Series ...

Sep 30, 2015 | 1998 Jeep Grand Cherokee

2 Answers

Fa goes off when ac on thn comes back onwhat may be wrong 1999 jeep grand Cherokee


Check for melted wires or connector at the blower resistor. It's located near the blower motor which is under the dash above where the passenger's feet go.

Mar 04, 2015 | 1999 Jeep Grand Cherokee

2 Answers

Why has my a/c stopped blowing


Could be a blown fuse or a problem with the blower motor or resistor/controller, but on the AZC (automatic zone control) system, many times the problem is a melted connector on the blower motor controller. Look up in the passengers footwell area, there you will find the blower motor (fastened with three screws) and next to it the blower motor controller..

Jun 17, 2014 | 2000 Jeep Grand Cherokee

1 Answer

Blower motor only works on high for 2004 jeep grand cherokee what is the fix ?


This is caused by a defective blower motor speed control resistor. The resistor is located next to the blower motor with one end going into the air ducting and the other sticks out with an electrical connector on it.

Jun 10, 2012 | 2004 Jeep Grand Cherokee

1 Answer

My 2004 Jeep Grand Cherokee AC blower works fine, but blows only warm air.


Hi!

Check if the system is charged with gas. Check if the compressor is working. Check if the damper motors inside are working

May 16, 2011 | 2004 Jeep Grand Cherokee

2 Answers

Heat/AC Blower fan speed only works on High


hello, this sounds like a bad blower motor resistor!! its cheap and easy to change..if you need more info on locations let me know,, good luck.....marty

May 27, 2009 | 2005 Jeep Grand Cherokee

1 Answer

2001 JGCL heater blower motor works intermittently If you wiggle wire on blower control unit it works. I replaced wiring with new Mopar wire set. Now, it does not work at all.


Check control unit for any burning or melting at contacts for wire harness. If damaged, change it. Also, you may have a problem with the blower motor causing excessive draw. This will cause switch /wiring to overheat. Make sure that wires do not get hot before stuffing everything back into dash.

Mar 07, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Old owner chopped blower motor wiring - need pinout for resistor


It might be beneficial to you to go to a scrapyard and take a look at one that hasn't been chopped up! You may even want to buy whatever has been removed while you are there!

Feb 19, 2009 | 1997 Jeep Grand Cherokee

1 Answer

Fuse keeps blowing on 2004 Jeep Grand Cherokee


Your fan seems to be drawing way too much current, common with fan motors of all kinds when they are going bad. It will still blow, but hot wires and blown fuses in the normal circuit indicate you have an excessive load in the circuit. Fan motors create this condition regularly, but are often ignored since they are "still blowing."

Here's a cheap, easy way to test my theory:
Try a new fuse, the proper amperage, but leave the blower motor unplugged at the blower itself. That will tell you in a few rides if the blower was the culprit. (Which it most likely is.) I bet your #20 fuse will stop blowing and no more smoking pink wires! Hope this helps. Remember, blower motors are cheap, traffic tickets and dash fires are not. The blower motor draw is the logical thing wrong with this picture. Good LUCK! TT

Jan 28, 2009 | 1999 Pontiac Grand Am GT

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

663 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

66219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...