Question about 2004 Cadillac SRX

1 Answer

Remove hood insulator blanket

How to remove fastners holding on the insulator blanket on a 2004 cadillac srx

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Carefully pry the black plastic fastners holding blanket away from hood. these fastners snap into a bracket attached to the hood replace by inserting into the original hole

Posted on Dec 31, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

Change the front turn signal bulb on Cadillac SRX


I have found a short cut for changing the front turn signal bulb
  1. Remove the inner fender well cover and then you can remove the light assemble from underneth and replace the bulb.
  2. The cover is attached with a bunch of push on body clips, pry the button up with a screwdriver and pull out fastner.
  3. Then there are two screws holding the light assembly on the bottom and inner side, it clips into the bumper on the outter side. From there it's pretty simple.
  4. FYI the GE replacement cross reference is wrong it's a Sylvania 3757A LL bulb.

on Dec 02, 2009 | Cadillac SRX Cars & Trucks

1 Answer

How to remove Cadillac srx center console


Open the lid fully, you should see small hold down bolt heads, maybe 7 mm...these must come completely out, be sure to label as length etc is important. There are also 2 front connectors to the lower dash, but depending on your need to remove, you may not need to remove these...you probably need to remove the gear shift knob to raise the console...look directly under the knob...sometimes a small pull out clip to release the knob, sometimes a allen head screw to release...hope this helps.

Jan 01, 2015 | 2004 Cadillac SRX

2 Answers

How do i replace my heater core in a 2004 cadillac srx


either rip the whole dash out, or take it to a shop that will.

Mar 20, 2012 | 2004 Cadillac SRX

1 Answer

My 2004 srx some thing is draining the battery, i have had it check and the battery is good, stater is good,


It sounds like you may have a dead short some place. This typically occurs when a the plastic insulation gets worn off of a wire. You may want to check any wires that are in your door jams because that is usually where this happens. I hope this helps.

Aug 30, 2011 | 2004 Cadillac SRX

1 Answer

How do u change the front signal bulbs on SRX 2004 with out taking the whole car apart???


Remove the bottom plastic cover along the front grills by pulling the push pins which hold them in place. You can slide the cover out . Remove the plastic cover inside the wheel which is also held by push pins.

When both the covers are out you ca use an 9/32'' wrench to remove the two bolts which hold the whole lamp assembly.You then need a torx driver to remove the six torx screws in the light assembly and you can replace the bulb.

Jan 04, 2011 | 2004 Cadillac SRX

3 Answers

I need to change the left front turn signal bulb on a 2006 Cadillac SRX? Looks difficult. Paul LeMaster


hi Paul

Should be able to open the hood remove plastic headlight cover & pull pins (2) on light assembly whole light assembly will pull out then replace turn signal.

Good luck.

Dec 02, 2009 | 2006 Cadillac SRX

1 Answer

How do i remove the subwoofer?


Remove the panel it's mounted in and remove it. Don't run the system without it though, it will unbalance the output and could blow the output transistors.

May 25, 2009 | 2004 Cadillac SRX

1 Answer

Starting disabled remove key


VEHICLE ANTI THEFT SYSTEM HAVING PROBLEMS

Apr 14, 2009 | 2004 Cadillac SRX

Not finding what you are looking for?
2004 Cadillac SRX Logo

Related Topics:

304 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...