Question about 2005 Chrysler PT Cruiser

Open Question

Wiring diagram for 2005 PT Cuiser about door locks

Con anyone send me info on PT cruiser door lock common bugs?
Pls reply here soon or email to tim4him@homail.com
Thank you

Posted by on

  • Tracee Kelly Jan 23, 2009

    I also have a 2005 PT Cruiser with bad electric door locks. It started with the trunk only, but after some time, all doors quit working. The doors randomlly locked themselves for awhile before going out. Any help would be greatlly appreciated.

  • yadayada
    yadayada May 11, 2010

    Have seen very few problems with this car, nothing stands out.

×

5 Suggested Answers

  • 625 Answers

SOURCE: 2001PT Cruiser door locks

make sure than the car has not any aftermarket alarm installed if it does have it remove it

Posted on Jun 01, 2008

66 chrgr
  • 1011 Answers

SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?

the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?

Posted on Jan 25, 2009

JShreader
  • 50 Answers

SOURCE: NEED WIRING DIAGRAM FOR 2002 PT CRUSIER STARTER

Hello chk614, my name is JShreader. Thank you for choosing fixya.com.

Here is a picture showing the Wires connecting to the Starter...
42ff1ef.jpg
If you are looking for the formal Wiring Diagram...see below...
8f3c163.jpg
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!

Posted on Apr 01, 2009

seans46
  • 161 Answers

SOURCE: Reply-SUSPENSION-03 pt cruiser touring

is it a nosie your talking about ? if so check the sway bar links make sure they are tight and not cracked or worn in anyway, then check upper control arms as well as tie rod ends. I have seen so many people try to replace everything for a noise and it was the tie rod end! they are very sneaky and can sound like a control arm. same with the sway bar links.you can take a jack put it under the control arm jack it up to where the tire is barely off the ground take a pry bar or strong long bar put under the tire and lift up & down while someone looks under at suspension parts you can also buy a automotive stethoscope for like 10$ to listen to each as you do that. most part stores sell them.

Posted on Jun 15, 2009

66 chrgr
  • 1011 Answers

SOURCE: 2005 pt cruiser misfire low rpm

Have your plugs and wires checked for replacement:)

Posted on Jul 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for the rear defroster for a 2005 P.T. Cruiser ?


Look at number 15 on the diagram that should be it.

Pls rate. Thank you.
10_4_2016_1_05_45_am.jpg

Oct 04, 2016 | 2005 Chrysler PT Cruiser

1 Answer

Pt cruiser lock cylinder change


On most cars the lock cylinder slides thru the door and a clip slides onto it to hold it in place. You have to, obviously, remove the rod that connects to the lock mechanism as wll

Jul 30, 2016 | 2005 Chrysler PT Cruiser

1 Answer

"How do I put this back together Door lock latch diagrams"


does it look anything like this , sorry hav'nt got the item list , get a workshop manual if this is not helpful , keep me posted if you wish
np01415.gif

Jun 02, 2014 | 2001 Chrysler PT Cruiser

1 Answer

Where is BCM located on 2002 PT Cruiser locks working even when car is not on have been told to check BCM don't know where to find it


I don't find a body control module for your car, but according to the wiring diagram the door locks are controlled by a keyless entry module which is located on top of the dash behind the ac vents.
There are three fuses that power the module.
Check with your dealer for more details.

Aug 20, 2012 | 2002 Chrysler PT Cruiser

2 Answers

Trunk will no longer open on my 2005 pt cruise without a key it was always automatic like opening doors. any suggestions?


Yes, I have a suggestion: diagnose the problem with your door lock actuator or the door lock actuator circuits to your trunk.

Aug 15, 2011 | 2005 Chrysler PT Cruiser

1 Answer

2002 Pt cuiser code# po605 & po700


the 605 is an internal Tranny computer failure U will need a tranny computer no way around it. It will also need to be programed as well once installed.

p0700 also has to do with the transmission

Jun 25, 2011 | 2007 Chrysler PT Cruiser Touring Hatchback

2 Answers

My 2001 pt cruiser auto door locks no longer work nor does the key fob. The door locks were acting like sssharp's - doing their own thing and locking or unlocking on their own and rattling in the back door...


As stated above, it is most likely your RKE (remote keyless entry module). It is easy to find and relatively easy to replace yourself. I just recently did so on my 2002 PT Cruiser. Got a used module from a 2005 at a salvage yard. Put in the module myself. However, you do have to take it to the dealer to reprogram so your remotes work with the module replacement. That cost me $50. If you are interested in doing the labor yourself, email me. K4qts@aol.com

Jul 06, 2010 | 2002 Chrysler PT Cruiser

1 Answer

My car sucks help me please 2006 pt cuiser


I would check into the timing belt sounds like the timing is off.

Apr 13, 2010 | 2007 Chrysler PT Cruiser Touring Hatchback

3 Answers

Horn does not work


Where is the fuse for the horn on a PT Cruiser

Apr 09, 2009 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
2005 Chrysler PT Cruiser Logo

Related Topics:

271 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...