Question about 2000 Chevrolet Blazer

1 Answer

2000 Chevy Blazer Computer/Brain Location

I need to replace my Computer/ Brain as people like to call it to my 2000 Chevy Blazer, I have to remove it to order the part but I can't seem to find it.

Posted by on

  • Tinkertoys1 May 11, 2010

    Little black box is what we call it. WHY? Where you doing some arc welding on the body and forgot to disconnect the battery? If you need to reset it, pull the NEG terminal off the battery and turn you headlights on, leave it for 5 minutes. After that, turn your lights off, reconnect the batt. Take it for a run out on the highway, don't spare the horse pwr, stomp on it. Once you 're-train' the 'brain', it should be ok. This is like a 'cold hard boot', just like your home 'puter

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 47 Answers

It is mounted on the RH inner fender under the hood. It's a black metal box with fins on it and a few large wiring harnesses going into it. You MUST have the battery disconnected when you hook the new one. Good luck

Posted on Jan 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 chevy blazer power brake booster


Chevrolet Blazer 4x4 Mid Size need to replace the power

I found this link for the removal of the booster. It looks like one of the retaining nuts that holds the booster to the forewall is difficult to get at.

Jun 08, 2014 | 2000 Chevrolet Blazer

1 Answer

How do you remove the starter from 2000 blazer


raise the front of vehicle & support on jackstands.It will help to take off the (left wheel on2.2L models,right wheel on 4.3L models)Remove skid plate(if equipped)On 2.2 models remove front driveshaft.On some early models,it may be necessary to raise the engine/transmission with a floorjack an under the transmission and remove the transmission crossmember for access to the starter motor bolts.On models so equipped ,remove the starter heat shield.From under the vehicle, disconnect the solenoid wire and battery cables from the terminals on the solenoid.Remove the starter mounting bolts, and then remove starter motor (note location of shims)

Jul 19, 2010 | 2000 Chevrolet Blazer

1 Answer

Location of fuel filter on a chevy blazer


driver,s side frame rail about at the rear of driver,s door on the inside of the frame rail should require a 16mm and a 20mm wrench to remove lines caution the fuel maybe under pressure

Jul 12, 2010 | 2000 Chevrolet Blazer

3 Answers

How replace turn signal switch 2000 chevy blazer?


Since the 2000 chevy blazer is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.

Oct 07, 2009 | 2000 Chevrolet Blazer

1 Answer

Rear speaker replacement on a chevy blazer


You need to remove the rear seat there is no other way of taking them out without removing the rear seat

Aug 15, 2009 | 2000 Chevrolet Blazer

1 Answer

Airbag removal 2000 Chevy Blazer 4.3l


there should be 2 or 4 bolts/screws on the back of the steering wheel

Jul 18, 2009 | 2000 Chevrolet Blazer

1 Answer

Need how to and location to replace knock sensor


Im looking for the same part location on a 2002 chevy blazer. It might be under the distributer cap.

May 30, 2009 | 2001 Chevrolet Blazer

2 Answers

Need to know location of coolant temp sensor in 2003 Impala


Usually found either on thermostat housing or close by on the lintake manifold. Usually can be removed with a regular wrench.

Mar 04, 2009 | 2002 Chevrolet Blazer

1 Answer

Where is the pcv valve on the 2005 chevy trail blazer


It is located on top of the valve cover. Buy the new one and you will see what it looks like, then you will pull the hose off of it and put the new one on, 5-minutes at top to do this job.

Feb 08, 2009 | 2000 Chevrolet Blazer

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

730 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...