Question about 2004 Hyundai Santa Fe

1 Answer

2004 huyandi santa fe

After two crank sensor,s new timing belt car still wont run ,runs a couple of days and stalls

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Have you had fuel pump checked?

Posted on Dec 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 Santa Fe had he check engine light come on several times in the past week. It started to run rough, like it was going to stall, then the check engine light came on. I took it to a mechanic. ...


Probably not a glitch but an possible issue with the crankshaft position sensor intermittently losing its signal to fire the coils.The crank sensor should be ohmed out when the vehicle is warmed up and when it is cold just to verify that it stays with in operating specifications.If it does not then it will need replaced.

Mar 22, 2011 | 2006 Hyundai Santa Fe

1 Answer

Whenever it rains my 2004 Hyundai Santa Fe will not run well. Today it sputtered and died several times. Now its running again that it has dried out. What is causing this?


We went through this with ours recently. Hyundai diagnosed it as a bad crank shaft position sensor. We replaced it and we're up and running again. Not sure why the damp weather affected it but it did.

Sep 20, 2010 | 2004 Hyundai Santa Fe

1 Answer

Check engine problem


plug it into a scan tools .it could be a camshaft sensor or crank sensor ,,scan tool can deside this

May 11, 2010 | 2004 Hyundai Santa Fe

1 Answer

2004 Hyundai Santa Fe 2.7 all wheel. Crank sensor


Hi

On the 2.7 engine it is located beside the starter. You will have to remove the starters heat shield to gain excess to the crank sensor.

Jan 25, 2010 | 2004 Hyundai Santa Fe

1 Answer

'04 santa fe V6 2.7 AWD. Runs fine 5 days straight. Sits from Fri-Sun unused. On Sunday when I go to fill up for the week of driving, I have a hard time starting. Once started, Rpms wont go any higher than...


dear friend-your problem might be the crank angle sensor as your problem is intermittend.your vehicle goes into limp mode.i suggest you take this vehicle for a diagnostic
test to find fault codes

Jun 22, 2009 | 2004 Hyundai Santa Fe

1 Answer

Location of crank position sensor 2003 santa fe 4 cylinder


hi the sensor is in with the timing belt. You will have to remove the timing belt cover and belt to put a new one in. You will also see a small gold metal rotor that spins on this sensor also replace that or it will trash the new sensor.

Mar 24, 2009 | 2003 Hyundai Santa Fe

1 Answer

I put on new timing belt and crankshaft belt and it will not star


change it out and find out if its the sensor or nor if you get fire to the plugs its not the sensor if you dont get fire then it probaably is

Mar 01, 2009 | 2004 Hyundai Santa Fe

Not finding what you are looking for?
2004 Hyundai Santa Fe Logo

Related Topics:

735 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...