Question about 1998 Jeep Cherokee

1 Answer

Fan motor switch on 98 jeep cherokee only works on high

Air conditioner and heater will only work on high speed, but they work

Posted by on

  • Anonymous Mar 28, 2014

    heater worked on high. was very loud. now doesn't come out at all..

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 104 Answers

In many cases this is the result of the blower motor resistor having gone bad. They are often located in the housing that holds the blower motor but I cannot say 100% for sure with the Jeep Cherokee.

Posted on Dec 30, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater / air conditioner fan control doesn't engage fan. Previously, it only worked in high speed.


I would replace the blower motor resistor first then see if that corrects this. The resistor is located next to the blower motor under the dash.

Jul 16, 2012 | Cars & Trucks

1 Answer

Heater fan 98 jeep cherokee not blowing


This should be a really simple fix if you posses a automotive test lamp to check the circut of the blower motor.

If you have a test lamp, ground the connector terminal on the fram of the vehicle, prob the tan and black wire at the blower motor and the light should come on when turning the switch to high speed, check at the blower motor connector. if you have power then you may have a defective B/M.

Also check fuse #46 at the power distribution center under the hood.

hope this helps.

Rodney

Jun 11, 2011 | 1998 Jeep Cherokee

1 Answer

My heater fan on my 99 jeep chereeke Larado does not work on high and the next lower squeeks so bad at first and then quits and does work but it's getting colder and I need the high to work.


heater fan relay i believe blower motor relay it controls the speed of the fan or your blower motor may have something stuck in it or its starting to go bad

Dec 03, 2010 | 1999 Jeep Cherokee

1 Answer

Jeep cherokee 2000 heater fan does't run


If it doesn't run on any speed then check fuses and relay's under the hood in the power distribution box,if all are good then use a test light or volt meter on fan motor wires with fan switch set on high,if you have power there then replace fan motor,if the fan works on some speeds and not others than check the fan speed control module,it is located in the air duct on pass side below glove box.

May 03, 2010 | 2000 Jeep Cherokee

1 Answer

My 95 jeep cherokee heater switch on ly works on high


I would try to replace the blower motor resistor first,If that doesnt repair your problem you may wanna try replacing the blower speed switch.The resistor is located under the passenger side of the dash mounted in the heater box.

Jan 30, 2010 | 1996 Jeep Grand Cherokee

2 Answers

Blower motor only works on high on 98 jeep grand


you need a temp limited switch and for the most part its close to the blower motor has a small screw on each side with a plug in the middle give these websites a try www.autozone.com and www.alldatadiy.com if all fails stop by your Jeep dealership in the parts department and they be able to show you what i am talking about and print you off pictures and diagrams showing you where it is located wish you the best of luck Michigan Man.

Jan 04, 2010 | 1998 Jeep Grand Cherokee

1 Answer

Interior fan won't run to run A/C or heater. I


If blower only works on high speed I would say blower motor resistor but if it does not work at all I would suspect blower motor. Make sure you are getting power to motor if not it might be blower motor switch.

Jul 02, 2009 | 1998 Jeep Grand Cherokee

2 Answers

Heat/AC Blower fan speed only works on High


hello, this sounds like a bad blower motor resistor!! its cheap and easy to change..if you need more info on locations let me know,, good luck.....marty

May 27, 2009 | 2005 Jeep Grand Cherokee

3 Answers

Heat/AC Blower fan speed only works on High


Alot of people have the same problem with the fan switch and blown bulbs. There really is no fix for this. Jeep really screwed up when designing the heater control assembly. The cheapest solution is to buy another unit off Ebay. Can always go to the dealer but be ready to PAY for there mistakes.

Jan 14, 2009 | 2005 Jeep Grand Cherokee

Not finding what you are looking for?
1998 Jeep Cherokee Logo

920 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

63291 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...