Question about 2000 GMC Jimmy

1 Answer

Engine will not start now

I just bought the suv two weeks ago inspected. The service so light stays on and the fuel gauge stays on full and some time flutters. Now the engine wont start and the low fuel light comes on, I just gas the suv up. Is there a trick to get it started to get it home. My wife's car cannot afford repairs now.

Thank You
dave
2000 GMCJimmy

Posted by on

  • jqclifton491 Jan 01, 2009

    Tank is full was running fine than it would not crank. When I try to turn it over the gas gage jumps to reading empty and says low fuel but tank is full.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had same problem the fuel pump is bad. it comes with a new sending unit also but dont buy the cheap one learned my lesson replaced it three times

Posted on Jan 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Gas gauge indicator goes to empty when full


sounds like you may have a bad fuel level sender problem. as for the check engine light coming on and storing a fault code that is a separate issue.

Aug 29, 2014 | 2005 Chevrolet Malibu

2 Answers

I began to have issues with my '05 Hummer H2 a few weeks ago.....


P0496 = "Evaporative emission system high purge flow"


At the dealership, we get a lot of complaints like yours and they all started with running too low on fuel or running out.


Start with replacing the fuel filter and get back to me.


Running low/out tends to suck up micro trash from the bottom of the gas tank and that gunk clogs the fuel filter.

Feb 02, 2013 | 2005 Hummer H2 SUV

1 Answer

2006 chevy malibu fuel gauge not working properly


just replace my fuel pump /sending unit on my 06 Malibu, didn't matter if the pump was in or out of the tank, the gauge still reads wrong

Aug 21, 2012 | 2006 Chevrolet Malibu

1 Answer

2004 Jeep Grand Cherokee temp gauge high when heat is on


If your "check engine" light is turn on, I suggest scanned the PCM to know exactly what fault code is stored there. Additionally, could be some problem with the "temp sending unit".

Keep us updated.

Jan 23, 2012 | 2004 Jeep Grand Cherokee

1 Answer

Car won't stay cranked after started


If the Service Engine Soon Light is on continuously there is a serious problem with one of the systems of your engine. Have it checked as soon as possible. Unfortunately, it could leave you stranded which will be very inconvenient.

Jul 03, 2010 | 2004 Cadillac SRX

2 Answers

Po463 fuel level sensor circuit voltage too high. how to fix?


fuel level sensor is part of the fule pump assembly. code is telling you sensor is malfuctioning. do gauges work? if yes i would leave problem alone till you need a fuel pump

Feb 23, 2010 | Isuzu Rodeo Cars & Trucks

1 Answer

While driving engine will lose power and start backfiring shut off for a while, restart and engine runs fine, replaced fuel filter two weeks ago, also had oxygen sensor and fuel level sensor replaced two...


usally back firing and no codes is a bad fuel pump or clogged pickup screen which is on the fuel pump.. you can get alge from the blended gasoline. see if you can run a prssure gauge to the out side of the hood and drive the truck, when the problems starts to happen look at the pressure. we had a k5 blazer do something similar. it would have 57 psi at start up and about 10 miles into dribving it we would have loss of power adn backfiring through the trottle body. feul pressure would drop to 17 psi. our pick screen was full of black alge from water in the gas.

Dec 30, 2009 | 2000 Chevrolet Silverado 1500

2 Answers

Fuel Gauge Stuck on Full 98 Pontiac Montana


When gauge is pegged at full, usually means a bad ground. Check wires at fuel tank, wiggle around, maybe one came off. The bad news is it is hard to get to without removing the tank. Sometimes you can reach arm in and get to them. Also check body ground at read of van.

Jul 17, 2009 | 1999 Pontiac Montana

1 Answer

Oil gauge light staying on


Possibilities -

1. Failing oil pump
2. Engine sludge
3. Overfilled oil

Jun 09, 2009 | 1998 Ford Expedition

1 Answer

Engine light is on.


Your vehicle’s computer system has self-testing capability. When the computer senses that there is a problem with some of the components it stores the correspondent trouble code(s) in its memory and lights up the Check Engine or Service Engine Soon lights to tell you that there is a problem and you should have the car diagnosed and repaired. Not fluid related, but could be a small problem that's easy to fix now. Even a loose gas cap can turn the light on. Have a code scan, that's the starting point.

Dec 16, 2008 | 2002 Isuzu Axiom

Not finding what you are looking for?
2000 GMC Jimmy Logo

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...