2002 Mazda MPV Logo

Related Topics:

Anonymous Posted on Oct 07, 2012

How to know the pcm and tcm part no. mazda mpv 2002?

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Scholar:

An expert who has written 20 answers of more than 400 characters.

  • Expert 65 Answers
  • Posted on Oct 07, 2012
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Scholar:

An expert who has written 20 answers of more than 400 characters.

Joined: Oct 05, 2012
Answers
65
Questions
0
Helped
23384
Points
186

If there are no part #s listed on them by way of a stamp or a sticker, the easiest way is to call the dealership, ask for the parts department, and give them the vehicle year, make and model, and they can give you the part #s.

  • Anonymous Oct 07, 2012

    Thanks you so much.

×

5 Related Answers

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Jan 08, 2009

SOURCE: water pump replacement in a 2002 Mazda MPV

The reason is the water pump is driven off the timing belt, extra parts and allot more labor. No the eng does not have to be removed, labor time around 4 hours, parts about, about $125 US for parts, if it is a dealer add $75 US

Ad

Anonymous

  • 15 Answers
  • Posted on Feb 21, 2009

SOURCE: program remote control for mazda mpv 2002

Courtesy of: forums.mazdaworld.org

Try this, it works on several 2002 models:


Step 1: Open drivers door and leave open.

Step 2: Lock and unlock the drivers door using the power door lock switch on the door.

Step 3: Insert key into the ignition.

Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.

Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).

Step 6: ECU should respond by locking and unlocking the doors.

Step 7: Press any button on remote #1. ECU responds by locking and unlocking the car doors.

Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.

Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done

Anonymous

  • 15935 Answers
  • Posted on May 22, 2009

SOURCE: what's the firing order is for a 2002 mazda mpv 3.0L/6 cylinder engine?

b70a6c7.gif
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Anonymous

  • 4 Answers
  • Posted on Sep 01, 2009

SOURCE: Engine warning light on Mazda MPV 2002

There seem to be 4 sensors along the way in the air intake and emissions system.

My Check Engine light indicated a bad sensor 1, bank 2 code (I think).

I had my mechanic replace the sensor that was indicated as faulty... cost = $191.

Then the Check Engine light came on again (with a different code), and I had to leave the van with him all day.

Cost to replace and install that sensor = $115.

My advice: if the Check Engine light stays on *AND* your vehicle is riding rough, get it fixed.

Otherwise, put a piece of tape over that Check Engine light and save a couple hundred dollars!

Hope this helps, I do trust my mechanic fully.

Testimonial: "Thanks for taking the time to post your advice re my MPV problem. Although not a definitive solution, it's certainly good advice."

Anonymous

  • 80 Answers
  • Posted on Oct 04, 2009

SOURCE: 2002 mazda mpv firing order please

let me know if this help you....

0fc1a6a.jpg

Testimonial: "tank you that was very helpfull because i call to mazda and they tell me the coil number 5 was in the midle on back "

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

97 nissian hard body 4cyl. Transmission will it interchange with a 2002 xterra Transmission

automatic or stick mine was STICK
4wd or not, , we can not guess drive-trains, ever. why not post VIN?
the pickup with odd name,had one, super long ago. 86:(4wd+v6)
Ask Nissan this?
or any tranny rebuilder this? they all know this.
it has to fit
and not make the PCM/TCM go NUTz
if it fits and has all the wrong RATIO gears, the PCM will go completely nuts. b
but is not a Ebox at all.
(97 cars some had TCM and electronic full box shifting.
one has
RL4R01A is a what,? llets look it up googling, easy;

RL4R01A transmission is currently found in Nissan Pathfinders, 300ZX, 240SX, Mazda MPV's, B2200 and B2600i vehicles. Also the Infinity J30, M30, and Subaru Legacy vehicles have similar units.
RL is pure hydra matic
REL is electroncs
so you luck out on TCM there is no TCM here at all
so is more swap worthy.
the problem huge is, 4wd
and transmssions can have mounts very differnet,
even the bell can different from I4 to I6 or even for other brands of cars. learn to ask rebuilder this. they sure know this and it is complex.
for all I said here and lots more
some are setup for 3 or 4 different 4wd transfer case
SEE?
dont ask on the web lacking full VIN,.(unless lies are fun)???????
not told full spec on the 2 cars, that makes this impossible all.
not rold is this old to new or new to old.
so post what car is the target car, not told.
or not use interchange word at all say SWAP from X and To y
sorry that is the best I can do with little facts told.
0helpful
1answer

Will a pcm and immobiliser from a different mpv be reprogrmed to my mpv

Yes they reprogram PCM all the time they just need your VIN# But used PCM must Identical as in engine trans.and acessorary equipment
1helpful
2answers

Where is the pcm in a 2000 mazda mpv?

You can't test it, you decide if it is the problem by exhausting all other diagnostic possibilities before the $1000.00 part is replaced. The failure rate of this part is less than 2%, so be very careful that you are sure it is the problem.
0helpful
1answer

Mazda mpv wont start - gas is flowing to cylinders - plugs are sparking - fuel pump just replaced - compression @120 and holding - help

HI and welcome to FixYa!

Looks like that you have a bad PCM (powertrain control module). The PCM is like a car's brain that when it's faulty something will surely fail. If you happen to know someone who has a spare pcm then you may want to give a try swapping.

Hope this helps and thank you for using FixYa! Have a good one!
2helpful
1answer

I need a diagram of the exhaust system on a Mazda 626

0996b43f80203328.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Component Location Chart-2000 MPV

1 PCM 2 Mass air flow (MAF)/intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Fuel tank pressure sensor 5 Engine coolant temperature (ECT) sensor 6 Crankshaft position (CKP) sensor 7 Camshaft position (CMP) sensor 8 Knock sensor 9 Heated oxygen sensor (HO2S) (front, LH) 10 Heated oxygen sensor (HO2S) (front, RH) 11 Heated oxygen sensor (HO2S) (rear, LH) 12 Heated oxygen sensor (HO2S) (rear, RH) 13 EGR boost sensor 14 Power steering pressure (PSP) switch 15 Main relay


0996b43f8020330c.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Component Location Chart-2001 MPV

1 PCM 2 Mass air flow (MAF)/Intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Engine coolant temperature (ECT) sensor 5 Crankshaft position (CKP) sensor 6 Camshaft position (CMP) sensor 7 Knock sensor 8 Heated oxygen sensor (HO2S) (front, LH) 9 Heated oxygen sensor (HO2S) (front, RH) 10 Heated oxygen sensor (HO2S) (rear, LH)* 11 Heated oxygen sensor (HO2S) (rear, RH)* 12 EGR boost sensor


0996b43f8020330f.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Component Location Chart- 2002-06 MPV
5helpful
1answer
0helpful
1answer

Hard shifting from 2-3 and now no acceleration past 20 mph Have read about PCM recalibration and/or TCM re-flash. Niether has been done. What is the best way to approach this. Not sure if I trust the local...

is there a CEL (check engine light) on. if there is get the car scanned it could just be somthing as simple as a speed sensor. or try unhooking the battery for a little while to reset the computer.if no CEL is on and computer is reset and it still happends take it to a local aamco tranny shop for a diagnostic check
8helpful
1answer

2002 mazda mpv firing order please

let me know if this help you....

0fc1a6a.jpg
0helpful
1answer

REPAIR MANUAL NEEDED!!!!

The 2002, 2003 and 2004 Mazda MPV's all use the same Ford 6 cyl. 3.0 duratec engine. The Ford Escape and Mazda Tribute of those years use the same engine. Therefore if you need an inexpensive engine repair manuel for your 2002 MPV, get the Haynes ($20.00) 2001-2007 Escape/Tribute manuel. Mazda sells the a MPV shop manuel for $180.00. I also own a 2002 Mazda MPV LX. 75k miles.
Not finding what you are looking for?

279 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...