SOURCE: key is stuck in ignition and car wont start
When the battery is dead, the key cannot be removed. You can either charge the battery, and remove the key or, there is a access panel (small) under the steering column, remove this, and push a small pluger to the left, while holding the plunger, remove the key.
SOURCE: 1992 dodge 318 engine turns over, but no start. No
if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10
SOURCE: 1999 Dodge Ram 1500 Pickup error code p0171
This code means that system to lean, bank 1.
some of the possible causes to make this code set are
1. intake or exhaust leak,
2. problem with the air system.
3. MAF (Mass Air Flow sensor)VAF sensor (Volume air flow sensor)
4. fuel pressure/pump
5. injector(s)
6. HO2S (Oxygen sensor)
SOURCE: 2004 Dodge Ram 1500 pickup speedometer and odometer quit
I am having the same problem. I replaced the speed sensor on the rear diff. and the problem went away but when i started it the next day the problem came back. If you figure it out let me know.
SOURCE: mitsubishi galant 2004 key stuck in ignition
1st Remove Battery cable from Battery because the only time the air bags will deploy is when the key is in the ignition. I have tilt steering and when I put the steering wheel in the up most position. I came right out. But now it seems to stick more lately.
http://technoanswers.blogspot.in/2012/02/key-wont-turn-in-ignition-on-toyota.html
-------------------
How to remove ignition switch on VW Car models?
http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-ignition-switch-on-vw-car.html
-------------
http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-ignition-switch-on.html
-----------------
3,503 views
Usually answered in minutes!
×