Question about 1999 Chevrolet Tahoe

1 Answer

I have a 1999 chevy tahoe, and my reverse lights stay on is there a way to adjust them

Posted by on

  • howie-do-it Mar 23, 2009

    if i unplug the 2 plugins from the switch, should the back up lights go off or not? if they stay on after unplugging, then what could it be?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 144 Answers

The reverse light switch is screwed into the transmission,and there are no adjustments.

Posted on Dec 30, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace brake light swtch in a 1999 chevy tahoe


The switch is attached to the brake pedal. Remove the wiring connector and the switch will either have a clip securing it or will be held in place with a plastic bushing. If a plastic bushing is used, a gentle pull will be needed to remove the switch. Install in reverse order and check brake light operation for switch operation/adjustment

Jun 07, 2015 | 1999 Chevrolet Tahoe

2 Answers

1997 chevy tahoe wont start


could be fuel pump or even crank or cam , timing sensor. Did it start running strange before this?

Jul 04, 2014 | 1999 Chevrolet Tahoe

1 Answer

1999 Chevy Tahoe will not go into park at all all other gears work but feel loose


there is adjustment down on the ******. I will send you a picture, what you will need to do it put on the e brake,and block the tires. on the drivers side of the ****** the shift cable is located, pop off the cable from the arm and pull the white clip, when push the arm foward that is park,and then easily pull the cable to the arm and put back the white clip10_30_2012_8_31_59_am.gif

Oct 30, 2012 | 2000 Chevrolet Tahoe

2 Answers

My 1995 Chevy Tahoe brake light switch wont stay in position and the brake lights stay on. I replaced the switch and had the same problem.


Brake Light Switch REMOVAL & INSTALLATION
  1. Disconnect the negative battery cable.
  2. Disable the SIR system (if equipped).
  3. Remove the clip (R/V Series) or unclip the switch (C/K Series) and unplug the electrical connector from the brake light switch.
  4. Remove the switch.
  5. Installation is the reverse of removal.
prev.gif next.gif

Oct 07, 2010 | 1995 Chevrolet Tahoe

1 Answer

How do you replace the a/c controller on a 1999 chevy tahoe?


east tilt steering wheelturn key to run position shift into low gear with engine off. pull off front cover by hand very easy press tabs on controller disconnect controller reverse procedure for installation

Oct 30, 2009 | 1999 Chevrolet Tahoe

1 Answer

I have 2000 Chevy Tahoe Z71. The security light stays on


1999 chevy tahoe security light goes on while im driving does
not seem to cause any problem

May 23, 2009 | 2000 Chevrolet Tahoe

1 Answer

1996 chevy Tahoe put new motor in and gauges are off


is the distributer in correctly those only go in way only and there is no adjusting timing on those motors assuming it is the vortec motor

Apr 28, 2009 | 1996 Chevrolet Tahoe

1 Answer

1998 Chevy Tahoe reverse lights stay on with engine off


got to be faulty door lock system for factory keyless entry

Apr 24, 2009 | 1998 Chevrolet Tahoe

1 Answer

Left rear turn signal, brake light and reverse not working


Did you ever figure this out? I've got the same exact problem with my tahoe.

Apr 11, 2009 | 1999 Chevrolet Tahoe

1 Answer

Brake lights don't stay on when I press on brake pedal. I have a 1998 chevy tahoe. Can someone help?


Stay on or go on when brake peddle is used?  If there is no brake lights check the fuse, and there is a brake light switch by the blrake peddle arm. Check the wire and check to see if the switch need to be re adjusted. Worst youmight have to replace the switch. Good Luck

Apr 06, 2009 | 1999 Chevrolet Tahoe

Not finding what you are looking for?
1999 Chevrolet Tahoe Logo

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63577 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...