Question about 2004 Toyota RAV4

1 Answer

Rav 4 2004 tail light replacement

There is only one visible bolt i want to remove he assemly and clean out the lens but can't not get it to budge after removing the one nut.

Posted by on

  • Anonymous Jan 26, 2009

    Same problem, did you manage to remove it ?



    REM

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

There are 3 bolts & a push stud with a plastic cover. The two bolts hidden by the trim are more easily accessible with bulb holders removed. I would also suggest something to catch any falling nuts would be a good idea.

Regards

REM

Posted on Jan 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do i replace a left rear tail light lens


Open the gate. On the side there will be two screws or plastic plugs to remove. Pull the lens straight back. There are clips that hold it in the side. Replace what you need.

Jan 04, 2015 | 2010 Toyota RAV4

2 Answers

1995 honda odyssey - how do you remove the tail light lens cover to change the brake lights?


inside the rear cargo are are 2 pop out access flaps, remove them and peer inside. The Tail light guts are visible. Bolts to remove the entire assembly, or get some small hands to twist out the offending bulb sockets. Careful, body acces hoes have sharp edges.

May 10, 2011 | 1995 Honda Odyssey

2 Answers

Tail Light Removal on 03 Charade


Daihatsu Charade EL 2003 rear lens removal. Open the tailgate and remove the two bolts securing the lens assembly. Then get a good hold of the lens and pull out. You need to pull out the whole lens assembly since there are three plastic protruding 'clips' on the side along the lens. Please view attached pictures. Then turn the bayonet bulb holder, replace the slide on type bulb and reassemble everything back in place.
4_18_2015_5_22_46_pm.jpg4_18_2015_5_22_47_pm.jpg

Apr 17, 2010 | Daihatsu Charade Cars & Trucks

1 Answer

How to replace passenger taillight assembly on 2007 RAV 4 will I need to remove inner body panels, and if so do I need special tools?


remove your tail light lens assembly using a screw driver slide the lens and lift it off then push and slightly turn the busted bulb to remove.

Apr 07, 2010 | 2007 Toyota RAV4

1 Answer

Honda odyssey tail light remove instruction


Open liftgate, remove two small flaps covering bolts, remove bolts, and pull light straight back towards the rear of the vehicle. Dont go towards the side of the vehicle. It will feel like its not going to budge when removing.

Mar 29, 2010 | 2005 Honda Odyssey

3 Answers

How to replace rear turn signal light bulb. how do you remove the rear tail light cover so as to remove the bulb on 2006 Ford Explorer XLT


I just changed my rear turn signal. Really easy. There is two 1/4 inch bolts visible when you open the tailgate. Take both of those out and gently lift the light housing out towards the outside of the vehicle. There is two small clamps on the other side of the fixture that just slide right out when you pull on it. There you go

Feb 20, 2010 | 2006 Ford Explorer

1 Answer

How do i change the tail light on my 1998 nissan sentra?


the actual tail lamp lens of the light bulb inside the lens?

for the actual light bulb, open the trunk at the back of the lens there will be a grey circle connector, 1 is the turn light, 1 is the tail light, simply rotate that connector opposite of the position that says "lock" written on the circle connector, that pulls out and then you can turn the bulb and replace that.

for the actual lens, you will need a 8mm socket and possibly a pry bar or a hammer. there are 3 8 mm bolts at the back of each lens, find them, they should be at each corner of the light, take those out, unclip the bulb harnesses mentioned above, unclip any connectors, should be 1 white one, then hammer the ends of the bolts you removed, this loosens the seal around the tail light. simply pull the tail light straight out, if it wont come out varify you removed all bolts and connestions then proceed to use the pry bar or the end of a hammer to pull the light out which will pull out towards the outside of the car not into the trunk. takes about 15 mins to do very easy.

Oct 14, 2009 | 1998 Nissan Sentra

1 Answer

Can't remove 2007 nissan versa tail light assembly


You have to rip it out after removing the two 10 mm nuts, the catch at the front was not designed to let go until you bang it and cause the shade to break , stupidest thing I ever saw

May 31, 2009 | 2008 Nissan Versa

5 Answers

Tail light bulb burned out, can't remove ***'y. to replace.


Remove the 2 bolts as in the user manual. Slowly wiggle the tail light top then bottom as you pull straight back. Not slowly. There are 2 pin clips attaching it to the rear quarter panel.

Apr 09, 2009 | 2003 Subaru Baja

1 Answer

Removing tail light


Drop the tailgate - there are two torx style bolts holding the lens assembly in place. Remove both, then with some gentle force, pull the lens assembly straight back(there are two self seating plastic bolts that hold the assembly into the truck frame, towards the cab).

Once undone, there is a strip of three bulbs on one wired base, and that base is screwed to the lens assembly (4 phillips screws). Unscrew those, and the lens assembly is free from the base. You can then remove the bulbs, insert new ones, and reverse the process. Good luck.

Nov 02, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
2004 Toyota RAV4 Logo

Related Topics:

386 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...