Etc light come on when riding for about 1 hr and engine lights

use an ammeter to find it

it's easy, with one tool, near impossible with out, (pull one fuse each night, nah that sux)

http://www.fixkick.com/drain/drain.html

You Can Pull The ECM Fuse Leave It Out for About 1 Hr Or Over Night As Long As There Is No Mechanical Problem The Light Will Stay Off.

erase code again , then disconnect battery for a few minutes, reconnect, see if code comes back. hopefully this resets computer. you don\'t have a reset button on steering wheel do you ? replace your fuel filter, if you haven\'t lately. maybe that will help.

If you google ( resolder or solder dodge Caravan dash cluster ) you find pictures etc that will make it easier for you. It's actually a pretty common problem around that year. The solder in the cluster where your harness and wiring connector attach (at back) gets cracked and what your describing starts to happen. It's a matter of removing the dash cluster, remove cluster/circuit board from housing, flip it over and just re-heat/re-puddle the spots where the solder is on back of circuit board where that connector attached. If you want more info, feel free to get back to me, but I expect you'll find a good picture if you google it. Good Luck, let me know how it goes.

This is the reduced engine power light you need to have the vehicle put on a scanner to see what the malfunction is. Thanks Klay

It could be that something is knocking out the sensor. When was the last time you had your emissions tested?

The light is set to light by milage and it is to let you know that the next service is due. This is reset by removing the rubber grommet that is to the left lower corner of the speedometer and depress the reset button.

Try A DPFE sensor ( Differential FeedBAck ) sensor that controls the EGR .. Lemmie know

first problem, went to autozone. the guy that looked at your car was making pizzas last week. they pull codes and sell you every part you will buy. take the car to the saturn dealer and replace the bcm.

Make sure the gas cap is there and is fully tightened (it will click), a loss or missing cap will turn the check eng light on.