Air bag module for 2005 mustang - 2005 Ford Mustang

There are 2; a & b, under the carpet and nearly directly under the accelerator pedal.

under dash

Yes!!! You can replace it yourself.(Dont let others fool you into paying extra or telling you otherwise.)
-This is for pontiac grand ams 1999-2005 only.
-There are no frontal airbag impact sensors nor are there belt tensioners.
-The SRS system consists of only the (driver airbag) ,(passanger airbag),and the (airbag control module) in 1999-2005 grand ams.

If you crash/wrecked and airbags deployed you will need.
-Driver and Passanger airbags
-Airbag control module

You can buy cheap airbags from a local junkyard any year from 1999-2005 will fit.
You can also find an airbag control module for cheap at your local junk yard BUT YOU MUST FIND ONE WITH THE SAME (PART NO.) AND (SERV NO.) AS THE ONE YOUR REPLACING.The (part no.) and (serv no.) should be at top left of airbag control module.However it does (Not) have to match numbers under barcode or the numbers at the far bottom right of airbag control module.

After you get both airbags and airbag module
-Disconnect car Battery
-Replace airbags
-Replace airbag module (under passanger seat)
-Double check all connections and connect battery.

Congradulations!Your airbags should be back online.

Notes: Two torx 35 head screws hold the driver airbag, access is through two holes behind steering column.
To remove passanger airbag you have to remove glovebox it uses (7mm)screws.After you remove you will see a pair of (10mm)screws holding airbag.
To remove airbag control module First remove passanger seat 2(15mm).Then after removing you will notice a raises area kinda like a vertical bump.Take a razor blade to your carpet and cut it to explose the module underneath.
The airbag module is held by three screws depending on the year of your car it varies.Most likely 3 (10mm).

Hello andread41,

It is under the center console between the front seats.

Regards,

netvan

The air bag module or the inflatable restraint sensing and diagnostic module (SDM) as they call it is under the left front seat.

air bags are not fused. The fuse is a link that blows on the circuit board of the airbag diagnostic monitor whenever the system is deployed in an accident, so to replace the fuse u replace the airbag monitor module.

Nothing. What ever codes where in there will still be there.

ECMs for the airbags are a one time use item. There in no way (that I know of) to clear them if a bag deploys. If there was not any codes before you took it out you should be fine.

my 94 mustang air bag lite bleeks and i do not no why

What is on the #1 fuse circuit? What ever it is is bad, or shorted out in the wiring.