SOURCE: 1996 timing belt changed, lined up all the marks,
Hi my name is juan and lets try to solve this it is possible that when you rotated the camshaft the distributor last his position and this is why it won't start it may not be the problem but this happens a lot so open your distributor and aline up your marks on camshaft and the crankshaft then make sure the distributor is pointing near the #1 spark plug if is opposite give it a 1 more turn to the crankshaft line up your marks again and se what happens #1 spark plug is the closets to the front part of the engine on 4cil
SOURCE: how to put on ignition switch on a '88 mazda b2200
If you mean actually replacing the ignition switch on the vehicle with a locking column. You need to do this. Dicconnect the battery, remove the lower panel of the dash if there is any. There is a bolt on the steering column near the fire wall on most vehicles, remove this bolt, it will release the spline on the steering column. Disconnect all wiring going to the column, unbolt the column from the dash support. Remove the column from the truck, on the ignition switch you will see where the two shear bolts screw the assembly together, center punch the center of each bolt. Now drill the bolt with a 1/8" drill about 1/4" to 3/8" deep. Now use a 3/8" drill and drill out the shear head until it comes off the bolt. You can now remove the switch assembly from the column. The new assembly should come with new shear off bolts so when you bolt it in place when tightned they will break off rendering it tamperproof again. Most vehicles are designed like this now to stop theft. Check the column for operation before reinstalling it in the reverse of above. You just want to make sure the key locks and unlocks the column before reinstalling in the vehicle. You may want to do this before you totally tighten the bolts and break them off permanently. Good luck, RAC
SOURCE: mazda engine bad
yes, i believe you could put any engine on your pick-up provided it is the rear wheel type set-up and the engine comes with its own tranny. problem is, if changing the engine mounts, tranny mounts, wiring set-up and exhaust system layout would not be of any problem to you. might as well look for the same mazda engine you have as a replacement to ease installation.
39 views
Usually answered in minutes!
×