Car starts but doesnt keep running
The relay just unplugs but that is most likely not the problem because if the relay was bad the engine would not start. It is my experience that the ignition starter switch is defective, they were recalled for many models and i think T Bird was one of them, so call the dealer, if not replace it yourself it is about $12.00. It is operated by a long steel rod from the ignition lock cylinder and is located near the bottom of the steering column on top of the tube. Drop the column down to replace it
SOURCE: E.E.C fuse keeps blowing in 1991 Ford Explorer
if you replaced fuel pump i would look at backward wiring when replaced and i would start at the source of work if your vehicle was working fine before replacement then 9 out of 10 it will be your fuel pump wireing
sometimes when putting wireing back together the connectors have the missing clip and in turn you can turn the wireing in both directions now where positive is touching the ground on both sides of connector kris kross problem check your work this is crucial use a test light to find the right wires where they go
SOURCE: my eec relay on my
There is a short some where in the circuit. Get a Haynes manual part # 36024 covers 91 thru 2000 it will tell you a lot of info on troubleshooting the wiring. Good luck
SOURCE: have replaced about all relays and sensors plugs
i think i would check the fuel presure regulator and the fuel presure if fuel presure low look at fuel filter if rail not holding presure then look at fuel presure reg and vac conection on it
SOURCE: EEC relay fuse
There are 3 relays mounted below the fuse box .
The green I believe is fuel pump relay and the brown is EEC. The third relay is for the A/C WOT.
It is possible the wiring is shorted, check there, it is also possible you have a bad fuel pump.
Please let me know what you find.
309 views
Usually answered in minutes!
×