Question about 2004 Mitsubishi Endeavor

Open Question

2004 Mitsubishi Endeavor will not start

It started up fine, but then engie start to run alittle rough, so i turned it off top restart it, but now it won't start, engie wil crank, but it won't turn over, any ideas ?

Posted by on

  • Djorda03 Jan 05, 2009

    My 04 Endeavor is doing almost the same thing. I started it and it started fine then started making a clanking noise so I shut if off and now it wont restart. Did you ever find a solution to your problem?

  • Colin Stickland
    Colin Stickland May 11, 2010

    petrol or diesel??

×

6 Suggested Answers

  • 3 Answers

SOURCE: Cabin Air Filter - 2004 Mitsubishi Endeavor (Where?)

IT IS IN BEHIND THE GLOVE COMPARTMENT YOU HAVE TO TAKE IT OUT BY UNSREWING AND START FROM YOUR RIGHT SIDE

Posted on Jun 10, 2009

  • 2 Answers

SOURCE: 2004 Mitsumishi Endeavor

The front three should be easy enough. They are right in front of the intake plenum. (big black plastic looking thing on top of the engine. The back three are underneath the intake plenum. It seems like a lot to tackle but it is really not that bad.
As always, if you are not sure you have the skills to attempt this go to a qualified mechanic. I did mine in an afternoon.

Posted on Jul 21, 2008

davidsspa572
  • 51 Answers

SOURCE: CHANGE HEAD LIGHT

Hello thank you for using FixYa.com my name is David,Here is the instructions you requested.

There can be slight variations in procedure from one model to another when replacing headlights. For instance, on some models the turn signal light assembly must be removed before the headlight can be replaced. Overall, however, the procedure does not differ much from the following typical instructions.
Make sure the replacement bulb is the same type and part number as the one that is being replaced.
To Replace:

  • Remove the headlight bezel retaining screws. Remove the bezel. If necessary, disconnect the turn signal lamp wires.
  • Remove the retaining ring screws from one or both lights.
  • Remove the retaining rings.
  • Remove the light from the housing. Disconnect the wiring connector from the back of the light.
  • Push the wiring connector onto the prongs at the rear of the new light.
  • Place the new light in the headlight housing. Position it so the embossed number in the light lens is on the top.
  • Place the retaining ring over the light and install the retaining ring screws. Tighten them slightly.
  • Check the aim of the headlight and adjust it, if necessary.
  • Install the headlight bezel. Secure it with the retaining screws.
  • Connect the turn signal lamp wiring (if it was disconnected).

Posted on Nov 08, 2008

SOURCE: Timing Belt for 2004 Mitsubishi Endeavor

Yes, I would replace it according to the owner's manual. Could be very expensive if it breaks.

Charlie

Posted on May 31, 2009

  • 179 Answers

SOURCE: Can not find the Cabin Air Filter on my 2004

This one is easy! Pull out glove box and there it is!

Posted on Jul 07, 2009

  • 3 Answers

SOURCE: We have a 2004 Mitsubishi

The rear suspension bushings are worn out. Same thing happened to mine. Wears out tires real fast too.

Posted on Dec 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 ENDEAVOR TURN OVER ,NO START


Check coil fuse -Could be a bad coil blowing the fuse

Mar 14, 2014 | 2004 Mitsubishi Endeavor

1 Answer

2004 mitsubishi endeavor - I changed the battery 2 days ago. I changed it as the car seemed as though the battery was going out, somewhat hard to turn over only at times. 2 hours after changing it, the...


hello allen team it seems to me that either your alternator isnt working properly and you will notice the battery light on andn it wont charge battery or you have bought the wrong battery as far as cranking amps i just bought the battery for my 04 endeavor and it had to be a 750 cca meaning cold cranking amps try to make absolutly shure that you have the right one there for the battery puts out the right amperage thus able to start the vehicle bye turning the starter motor at the corect rpm

Oct 19, 2011 | 2004 Mitsubishi Endeavor

1 Answer

Vehicle running fine. came out of work to drive. would not turn over, and odometer flashing like crazy


Your battery has failed and requires replacement.

Typically when you start getting the heiroglyphic flashes on the odometer it usually means the battery is too low to even jumpstart.

Oct 06, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Cabin Air Filter - 2004 Mitsubishi Endeavor (Where?)


IT IS IN BEHIND THE GLOVE COMPARTMENT YOU HAVE TO TAKE IT OUT BY UNSREWING AND START FROM YOUR RIGHT SIDE

May 31, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Rough idle


I took mine in to change the plugs and they said there are four O2 sensors in the fuel mixture system and two were bad. I didn't replace them since they were a little pricey ($500 to replace both) and I have 103,000 on the car. Has very similar roughness and occasional oscillations, but no stalling. Hope this helps.

Jul 21, 2008 | 2004 Mitsubishi Endeavor

Not finding what you are looking for?
2004 Mitsubishi Endeavor Logo

Related Topics:

375 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...