Question about 2006 Pontiac G6

3 Answers

Engine light 2006 pontiac g6(reset)

How do you reset the engine light on a 2006 pontiac g6?

Posted by on

  • 7 more comments 
  • more12913 Dec 30, 2008

    Thanks I was on here earlier and I did that and it worked fine..THANKS!

  • jr1749 Jan 26, 2009

    i don't have the manual, how do you know if it is the service light or engine light?

  • Anonymous Mar 13, 2014

    Pontiac g6 trunk light wont shut off

  • Anonymous Mar 20, 2014

    half of odometer are lighted up to speed 60.

  • Anonymous Mar 25, 2014

    My Pontiac g6 will not start up after it warms up unless u push the gas pedal when u are cranking the engine

  • Anonymous Mar 25, 2014

    My Pontiac g6 will not start after it warms up unless u push the gas pedal when u are cranking the engine over

  • Anonymous Mar 27, 2014

    can I reset the check engine light on a 2007 G6 without a scanner

  • Anonymous Mar 30, 2014

    My Pontiac g6 is running hot what's causing it to doing that

  • Anonymous Mar 31, 2014

    chec engine gt on

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

First be sure that its the engine light and not the "service" light. the service light will usually illuminate if its time for an oil change. if its the service light ur owners manual should tell u how to reset it. if its ur engine light then try disconnecting ur positive battery cable for 1 minute. that should reset ur ecm and get rid of the engine light. if the engine light comes back on then have a diagnostic scan done to determine whats causing it. LJ

Posted on Dec 29, 2008

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Take the negative battery terminal off the battery for one minute. Then replace the Battery terminal carefully, always use caution when taking off the positive battery terminal, and make sure the metal wrench you are using does not touch a metal part on the car. Always take off the negative battery terminal for one minute, then replace the negative battery terminal. This should clear your fault code and automatically reset your check engine light. If your check engine light come's back on. Your vehicle has another fault code that need's servicing on your vehicle. Sincerely Crystopper.

Posted on Dec 03, 2012

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

After replacing the gas cap .. unscrew the terminal from the battery for a minute. The easiest one is the one away from air intake from the air filter box. Just set it aside gently. Of course you need to reset your clock and your radio stations after screwing the wire back on.

Posted on Jul 10, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you reset the computer in 2007 G6 Pontiac?


If you just simply want to say make a check engine light go off you can just disconnect the battery for ten minutes and then reconnect it. But if you mean re flash then that has to be done by a dealer most likely.

Jun 01, 2014 | 2006 Pontiac G6

1 Answer

My 2006 Pontiac G6 won't start by remote. However, it will manually but a check engine light came on. What could be wrong with my car? Is it an expensive repair?


If you have a check engine light, the system is designed to prevent remote start or shut it down shortly after. Get the code checked and proceed from there.

Jan 04, 2011 | 2006 Pontiac G6

1 Answer

Cant find the power steering for a 2006 pontiac g6 (v6 engine)?


In 2006 Pontiac put ELECTRIC power steering in the G6's.

Your looking under the hood in the right location its just under that. its all electrical. Must have been not such a good idea because they switched back to normal power steering in 2007.

(I have an 06 G6 V6)

Dec 24, 2010 | 2006 Pontiac G6

1 Answer

Hello I need help locating the fuse/relay for my power windows on my 2006 Pontiac G6. My windows are stuck in the down position.


The 2007 Pontiac G6 engine compartment fuse block is located on the driver's side of the engine compartment, near the battery. The wiring circuits in Pontiac G6 are protected from short circuits by a combination of fuses, circuit breakers and fusible links. This greatly reduces the chance of damage caused by electrical problems. Below diagram and table shows 2007 Pontiac G6 Engine Compartment Fuse Panel, Relay and the Circuit Protected.
pontiac-g6-engine-compartment-fuse-panel_thumb.png The fuse is in location 50

Nov 25, 2010 | 2006 Pontiac G6

2 Answers

2005 Pontiac G6. The check engine light came on, reset it and now I do not have heat in my car.


Well lets see - resetting the Check Engine light will not, in itself, have anything to do with now not having any heat from your heater.

Why the Check Engine light was on in the first place may have a lot to do with it.

If your engine is low on engine coolant (antifreeze) your heater will not work. Low coolant levels and/or engine overheating will also set fault codes in your computer and turn the Check Engine light on.

NOTE:
It is NEVER good to reset a Check Engine light without properly diagnosing and repairing the reason it was on. At best, it could wreck your catalytic converters, making it extremely expensive to get through an emissions inspection. At worst, it could cost you an engine.

Oct 17, 2009 | 2006 Pontiac G6

2 Answers

I cannot get the Change Oil Soon message to reset on a Pontiac G6


Chevrolet Malibu, Malibu Maxx 2004-06; 2006 HHR, Cobalt, Pontiac G6, Solstice
Turn ignition to run engine off. Display OIL LIFE RESET in the Driver Information Center (DIC). Press and hold the ENTER button for at least one second. An ACKNOWLEDGED’ display message will appear for three second or until the next button is pressed. This will tell you the system has been reset. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Jul 17, 2009 | 2007 Pontiac G6 GT Convertible

1 Answer

Remote Start wont work pontiac G6


Thanks for the help but, I just have to wait till monday now because all the shops are closed. I have to find out why my check engine light is on first.

Feb 14, 2009 | 2006 Pontiac G6

1 Answer

I can't change low beams on front lights on 2006 Pontiac G6?


they are removed and replaced from inside the engine compartment.... you may have to remove the battery to replace one of them.

or... do you mean the switch isn't working

Dec 17, 2008 | 2006 Pontiac G6

Not finding what you are looking for?
2006 Pontiac G6 Logo

5,541 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...