Question about 1994 Saturn Sc

Open Question

Front Turn Signal Bulb Replacement

I have a 1994 Saturn SC2 and the left front turn signal bulb is malfunctioning. I have been unable to figure out how you get at the bulb to replace it as it is not possible to reach it from either inside the engine compartment or from underneath. I removed the windshield washer reserve but can't get in that way. There does not appear to be a fastener on the lens that is removable. Any suggestions would be a great help. Thanks.

Buddy

Posted by on

  • Anonymous Mar 16, 2009

    I have a 1992 Saturn SC2 and the left front turn signal bulb is malfunctioning. I have been unable to figure out how you get at the bulb to replace it as it is not possible to reach it from either inside the engine compartment or from underneath. I removed the windshield washer reserve but can't get in that way. There does not appear to be a fastener on the lens that is removable. Any suggestions would be a great help. Thanks.

  • painterdude Apr 28, 2009

    I too have 1994 saturn with the same problem trying to figure out how to get to the bulb. It's the right front turn signal. Any help ????

×

5 Suggested Answers

  • 73 Answers

SOURCE: 2001 saturn sc2 gets code 341&340 camshaft sensor

if you have high resistance in secondary ign. system (plug wires, ign.coil) this will cause this code to set. make sure you are using a high quality spark plug wire set. not from autozone!!! and denso non platinum tipped spark plugs. also use a diaelectric grease on plug wires to keep moisture out.

Posted on Mar 31, 2009

  • 73 Answers

SOURCE: part underneath the car

it is called the air damb, it directs sir to flow accrost radiator.

Posted on Mar 31, 2009

  • 3911 Answers

SOURCE: 1997 Saturn SC2 squeals very loud the first 3-5miles

Try replacing the belt tensioner. Comes out easily, once you figure out access to it. Remove inspection panel inside front passenger side wheel well. Tensioner is right there, two bolts. If the spring gets weak, the belt will squeak.

Posted on Feb 18, 2010

  • 3911 Answers

SOURCE: how do you remove the shell from a 1993 saturn sc2

remove the door handle, lift it up and you will see little plastic pins you can pull or push out. take off the mirror, look underneath the interior cosmetic mirror panel and you will find the bolts holding it on. Get a star driver and take out ALL the star head bolts holding the exterior panel onto the door. Lift the panel up and out.

Posted on Mar 22, 2010

drsinister69
  • 2317 Answers

SOURCE: 1993 1.9 saturn sc2 starting problems

Sounds like the the Bendix is bad in the starter, which pushes out the drive gear to engage the flywheel. You'll need to replace the Bendix or the starter. It's a bit tough to get to the starter, it is underneath the intake manifold.

Posted on May 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

My left turn signal was flashing fast. I checked bulb in back left. Turn signal good but bulb below it was out. I changed that one but turn signal still flashing fast. all other bulbs look good. ??


If the front and rear bulbs flash fast also, replace the hazard switch or you could live with it. As they are working. If one doesn't work, check grounds. I just run a new ground, much easier than cutting open the harness to find the break.

May 31, 2015 | 2012 Nissan Rogue

1 Answer

Front left turn signal doesnt work


The turn signal circuit is different from the parking lights. So the headlights would not be involved.
You should have power on one side of the bulb for parking lights and the other for turn signals.
If you have no power for the turn signal circuit, I would look at the turn signal switch. It powers each bulb separately.

Aug 21, 2012 | 2005 Saturn Ion 2

1 Answer

How do you change a front signal bulb on a 2004 accord


Front turn signal bulb replacement

1. Remove the inner fender
2. Disconnect the 3p connector from the front turn signal/side marker light.
3. Turn the bub socket ( 45 degree ), counterclockwise to remove the bulb.
4. Install a new bulb in the reverse order of removal.

Apr 12, 2010 | 2004 Honda Accord

1 Answer

I have a left front clearance light out how do you get it out 1


Signal and Marker Lights REMOVAL & INSTALLATION Front Turn Signal and Parking Lights
  1. Disconnect the negative battery cable.
  2. At the rear of the front bumper, turn the bulb socket 1⁄4 turn and remove the socket from the parking brake housing.
  3. Remove the bulb from the socket; if necessary, replace the bulb.
  4. If lens replacement is necessary, remove the retaining bolts and remove the lens from the bumper.
  5. To install, reverse the removal procedures. Check the turn signal/parking light operations.
Fig. 1: Common front turn signal/parking light mounting

d16c14b.jpg
Fig. 2: Twist and remove the bulb socket from the back of the turn signal/parking light lens

8b774bd.jpg
Fig. 3: If lens removal is necessary, loosen and remove the retaining bolts

09f4811.jpg

Jul 24, 2009 | 1992 GMC Sonoma

1 Answer

Left turn signal


Well, seeing that you have a multimeter, check power at the socket and make sure it has power there. If there isn't then your wiring has an issue somewhere.

Jul 24, 2009 | 2004 Saab 9-3

1 Answer

Front left turn signal bulb replacement on 99 taurus?


take the headlight assbly. out two bolts on top under hood

Feb 14, 2009 | 1999 Ford Taurus

1 Answer

How to access front turn signal for replacement


Here you go, removal & installation of:

Front Parking/Turn Signal Lights:
  • Remove the screws from the the lens and separate the lens from the bezel
  • Remove the screws from the turn signal housing and pull it out
  • Turn the bulb socket CCW 1/3 turn and remove it
  • Installation is the reverse of this procedure
Side (Front) Marker Lights:
  • Remove the screws from the marker lens
  • Separate the lens from the headlight
  • Pull the bulb from the back of the lens
  • Installation is the reverse of this procedure
Hope this helps

Mike

Jul 06, 2008 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

66219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...