Question about 2007 Mazda MPV

3 Answers

#5 cylinder misfire

2004 Mazda MPV 60,000 miles. Took van to Autozone to check the Code. Code shows #5 cylinder misfire. Changed spark plugs. Problem went away. Now its back. On cold days slight rough idle at 1st start up. No engine light. Drove van 10 miles and engine light came on and was flashing. Parked van 2 hours. Drove 10 miles back and no problems. Can I move the coil pack to see if problem follows? Thanks.

Posted by on

  • kchawgs69 Dec 30, 2008

    Thanks but my MPV does not have plug wires. It has a coil pack on top of every spark plug. I don't know if the coil pack could be
    Intermittent.

  • Anonymous Mar 15, 2014

    engine light blinking on ienna van code said # 6 misfire

×

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 53 Answers

I have a corolla and had #4 cylinder misfire also diagnosed at autozone. After changing the spark plugs, problem persisted, along with the same error code, so they recommended changing the spark plug wires, and that is what fixed it. I would have changed the rotor cap too, but was low on dough. Glad that was not the problem.

Posted on Dec 29, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Yes, it's around $470 with tax at the dealer for all 6 coils & secondary coils, the plug wire equivalent. Look for a better price online. Once you get the hang of removing/replacing the intake plenum, it's not that hard. I replaced all 6 at 70k miles and now she's running great again.

Posted on May 02, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 24 Answers

Time to change the coils. I'd replace them all as they will start to go bad one by one and continue to give you misfires. The three that are fun to get to are 1,2,3 and you have to remove the intake plenum to change them.

Posted on Mar 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda 2002 MPV cylinder 3 missfire


was the any oil on the coil boot? you can have a weak injector or a stuck vavle

Oct 31, 2012 | 2002 Mazda MPV

2 Answers

I have a mazda mpv 2000 minivan.problem code p0301 misfire detected cylinder#1


I'd check #1 spark plug.
Usually a misfire code "fix" is a spark plug, spark plug wire, or a coil pack / distributor.
Keeping it simple...I'd go with the spark plug first and then look at the condition of the wires.

Hope this helps...

Aug 28, 2011 | 2005 Mazda MPV

1 Answer

Misfire cylinder #4 was indicated as a result of the check engine light. How do you fix this or how much might this cost to fix? Frank


A Cylinder Misfire Code is usually a very simple fix. Most of the time it just means you may need to change the spark plugs especially if you haven't changed them in a long time, you may have a clogged fuel injector from having a dirty fuel filter. The least expensive thing you can do right now is to replace all of the spark plugs first and than go from there.

Apr 29, 2011 | 2004 Mazda MPV

2 Answers

Every time it rains my 2003 Mazda MPV misfires and sputters, then the check engine light flashes on and off intermittently. I ran an OBDII check on it and it reads cylinder 5 misfire. If I let it sit and...


may have hair line crack in coil,,or bad wire,,spay wire while running with a water missed spray bottle,,& see if u can make it misfire,,start at spark plug & work ur way up,if it starts to misfire when u get to the coil,,u will no with part to replace,,hope it helped,,

Apr 05, 2010 | 2003 Mazda MPV

2 Answers

I have a 2003 Mazda MPV , the problem only happen


I ahve same issue with my 2004 MPV. I replaced the plugs, coils etc. No help.

did you ever get it fixed?

Jan 21, 2010 | 2003 Mazda MPV

2 Answers

What could be the cause of a p0304 code on my 2005 mazda mpv. the check engine light is blinking


Cylinder 4 is misfiring. Take it to a mechanic and have them take a look at it. Im guessing its the distributor, Spark plug, or spark plug wire on cylinder 4

Dec 09, 2009 | 2005 Mazda MPV

3 Answers

Need to know the cylinder number locations on a 2004 Mazda MPV


Does anyone know the cylinder number locations??

Sep 22, 2009 | 2004 Mazda MPV

1 Answer

Error Code Cylinder 7 Mis-Firing & Vibration When Going Up Hill


yes i would change the plug wires , you can take a spray bottal with water and spray that wire, and if it starts to run real bad then it is shorting out, you may also have a injector going bad you can test this buy puting a ohms meter on it and ck the ohms it should read the same or close to the same as the other if not it will need replaced

Aug 14, 2009 | 2004 Dodge Ram 1500

1 Answer

Code scan: P0301 Cylinder 1 misfire detected


Code P0301 is a generic OBD Code for Misfire. It also indicates you have a misfire in the #1 Cylinder. I would start by checking the plug wire to make sure its clean and on all the way (at the coil as well). Then if that doesnt help I would pull the plug out and check the condition of the spark plug. hopefully this will give you some direction. Thanks for Using FixYa!

Sincerely,

JC

Dec 03, 2008 | 2004 Jeep Wrangler

Not finding what you are looking for?
2007 Mazda MPV Logo

1,501 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...