How can you bypass the pass lock oon it?
SOURCE: 2005 ford taurus. Remote entry wont work theft light keeps blinking when key is engaged
HI, I'm reading your problem,
Let me explain something about your car.
2005 Ford Taurus, The key on that car has Chip inside of the key and receiver on the ignition switch,
Check if the key you are trying to use is Black and has a plastic head.
If not you need a key with that characteristics.
But if you have the right key, Remenber if you had drop on the floor, or hit with something,
Because some times they come damaged, with insignificat thins.
Remenber if you left the key close to a magnets like speakers.
If nothing aply at your case, you need to call a place Aloha Smith, they have the computer to program or reprogarm your key. IF not you can't start your car.
OK.. I hope this information work for you.
Thank's for submit yous question on fixya.com
SOURCE: 2000 Windstar rebuilt engine won't crank theft light comes on
Refer to the owners manual for dis-arming procedure for the anti-theft, if you do not have the owners manual here is a link to Ford for a free PDF file of the owners manual.
http://www.motorcraftservice.com/pubs/content/~WOYWIN/~MUS~LEN/41/00winog1e.pdf
SOURCE: dont know how to reset or bypass gm theft system car is not starting .It tries and quits.
this is one way to reset it :
first make sure the battery is fully charged , then do the following:
key in the ignition but do not crank the motor, just leave it at the
ignition mode for ten minutes ,then turn it off POSITION for 5 seconds then REPEAT again 2 more times. at the 3 rd time youre gonna notice the ANTI THEFT light on dash to blink. when doing the last step , remove key , inserted again and turn on motor , good luck , AJ
SOURCE: I have a 1998 ford mustang 5 speed. the theft
The theft light blinking fast because there is a problem with the PATS ,(passive antitheft system). You either have a bad chip in one of your keys,PATS transceiver on ignition cylinder or computer. If it is a key you would have to have them programmed into system which requires you to have 2 keys and certain diagnostic equipment to program them into sytem. I would take it to your service provider or someone who has the equipment to do this like a ford or lincoln, mercury dealer.Have a good one!
SOURCE: 1998 ford expedition wont start. theft like is
If you are reseting a factory alarm...lock and unlock the drivers door with the key.
If you don't know the code look under the dash driver side in left corner there should be a black cover with a sticker with a code on it 6 numbers that is the factory code.
116 views
Usually answered in minutes!
×