Dashlight location for a 1999 sebring convertible

images for Where is the location of ignition module on ...R

1999 Chrysler Sebring Convertible, Ignition Coil in ...

? 7:25
https://www.youtube.com/watch?v=E48b4F_-PJw
Jan 31, 2011 - Uploaded by syyenergy7
Ignition Coil in Gen I distributor, Chrysler Sebring convertible. ... I have a 1997 Sebring Convertible and it has the 2.5v6. .....Some reason I thought this was about replacing the cam position sensor, now I realize it's actually the ...

the dash is big place, you meant cluster?
please state at least one bad bulb.
there are over 20 lamps that glow now
most are LED now, and are NO removable.

eg:back ground lamps? dash dimmer set too low?
CEL /SES dead.
VFD dead.?
warning lights dead, 1 or all?
when you key on any car the whole cluster, glows, this is called
power up self test, if this fails, you have a dead battery or blown fuse.
post exact symtoms and can advice exact fix.
or read the FSM.

should be held in with screws under dash pull down and the rezistor should be close to teh center console on teh botum of teh heater box

if it is a small red light and no symbol beside it then it is a security light. try locking all the doors and unlocking each one with the key.

It may not be a bulb, as the instrument cluster usually has a number of bulbs and they probably didn't all blow at once. Pulling instrument clusters can be touchy and may not be for the average "shadetree mechanic" however, typically there are a few screws above the cluster going into the dash pad and a few hidden behind the trim panels below the cluster.

There should be a switch on the dash or the headlamp switch. they will only work on LOW BEAM. it is possible that both bulbs can be bad.

Change the flasher which is located up by fuse block under dash

So, this is not a 2000 Hyundai Sonata? I used to own a 2000 Honda Civic and I believe those lights get power from a fuse inside the fuse/relay panel located on the driver's side under the dash. Check all your fuses. If all fuses are good, you've got a wiring problem - check for power & ground at each bulb. Obviously, if you don't have power to them, it's a power distribution/wiring issue. If you do have power to them but no ground, it's still a wiring issue.

both headlight bulbs need changing/ check the fuse first under the dash and in the engine compartmentplease rate my response thank you very much

try takeing a wire tester and test the wires running to your dash lights to see if they are getting power