SOURCE: how to remove and replace Tata Indica gearbox
not a bad little car i think,done one last year for a new clutch and i it was that easy that i honestly do not remember having any problems with it ,only one tip i will offer though and i do this on all motors and thats to drill a hole in the bellhousing with a hole cutter big enough to get a 10mm socket 1/4 drive through the hole to tighten the clutch bolts ,getting to old to struggle now so i make a hle that aligns up with the clutch bolts then fit bolts holding the clutch finger tight then once the box goes in nice and easy as the clutch plate can move a bit then two big bell housing bolts in and then rotate the flywheel twic tightening the bolts one by one .easy better than hurting ones back with a struggle
423 views
Usually answered in minutes!
×