Question about 1996 Land Rover Discovery

2 Answers

I washed under the hood of my 96 4.0 land rover wont start now

It was trying but now it has no spark, i havehad a fan on it for 5 or 6 hours it will start if i use starting fluid but dies again quickly. it was running great before now i feel like a *******. please help me if you can thanks
csand1221@hotmail.com

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

Clean and warm plugs then try

Posted on Dec 29, 2008

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 45 Answers

Try spraying leads coil distributer cap inside and out with wd40 but make sure you dry excess fluid off its a must cos it flamable this should do the trick,, so spray on wipe off..

Posted on Dec 29, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alarm system 96 land rover discovery


You can't remove alarms or bypass them, you have to fix them.

Disconnect the battery fully for at least 2 hours.
Hold the negative and positive leads together for 5 minutes.
PUT THE KEY IN THE IGNITION, but not turned on.
Connect the Positive lead to the battery.
Connect the Negative lead in one swift movement.
Wait 15 minutes for the ECM to re-pair the chips in the key and the ignition key.

My mother worked at Land Rover in Solihull for 18 years :>)

Want to bypass your vehicle security system

Nov 16, 2017 | Land Rover Cars & Trucks

1 Answer

Hood Release 1998 Land Rover Discovery I


You can adjust release on front brace by loosening bolts and setting it. I grease all my latches with moly grease. And lube cable under dash shield.

Feb 23, 2013 | 1998 Land Rover Discovery

1 Answer

Suggested Solution 2002 Land Rover Discovery Series II Logo Problem with 2002 Discovery Series II Starts fine when cold, after running dies on idle then wont start 2002 land rover discovery, starts fine...


The ignition system is controlled by the ECM. Check power at fuse box in on right side under dash. Check fuses right side engine compartmentlower dash panel if all OK check power to ECM located right side "A" pillar in alloy box. this unit could be faulty if no spark at coils, assuming they have been connected correctly. may have to get tested for codes at L/R dealer or someone with test tool. Another source of problem may well be flat battery in transponder key. The indicator light on the dash willflash rapidly for 10 seconds if the vehicle has been unlocked with the remote and the drivers door is opened if the battery in remote is getting low

Dec 02, 2012 | 2004 Land Rover Discovery

2 Answers

Help 1999 land rover range rover


Are you saying it will start at some point in time ?
A no start condition requires you to figure out if it has no spark to the plugs or no fuel to the injectors.

Jun 28, 2012 | Land Rover Range Rover Cars & Trucks

1 Answer

Range Rover


Check for breaker fuse under hood.

Oct 14, 2017 | 2006 Land Rover Range Rover Sport

2 Answers

Where is my fuse box in my 96 land rover d1


There's 2 - 1 is under hood passenger-side upper fender-well, the other is under steering column - panel Driver side. Two large plastic screws, turn 1/2 way and panel drops

Mar 05, 2011 | 1998 Land Rover Discovery

4 Answers

I 96 LAND ROVER START PROBLEM


fuel pressure problem.when you kill it it is supposed to hold pressure.your getting air in it.not good. take to a mechanic. its a deep problem

Apr 28, 2010 | 1996 Land Rover Discovery

1 Answer

Power washed under the hood probaly got the distributer wet.


Take the distributer cap off and dry everything it should start then

Dec 29, 2008 | 1996 Land Rover Discovery

Not finding what you are looking for?
1996 Land Rover Discovery Logo

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

yadayada
yadayada

Level 3 Expert

77544 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...