Question about 1999 Oldsmobile Intrigue

1 Answer

Aternator replacment on a 99 olds intrigue

Do i really have to pull the radiator? or am i able to slide it through the front right wheel well?

Posted by on

  • chuckntanya Jan 01, 2009

    I dont know about that - your motor must be set up diff than my 98 which is fairly easy to get to - BUT.....if you are havin alt probs GOOD LUCK MY FRIEND! I been havin ALOT of elec probs, doin TONS of research, already replaced alt 3 times,battery, wires, etc - these cars are KNOWN for bein problematic in that dept!! ESPECIALLY in cold weather! but I just recently read about a replacement alt containing circuitry to stop voltage spikes causing these continual probs - DO NOT just purchase a re-man, or you'll be doin this same **** all over again!



1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 2 Answers

I changed my alt on my 99 and had to take battery out,belt off, the slides on... its only held in with 1 bolt and are on runners(but the big problem is its a VERY tight space... make sure you have a 15 in rachet.. or a open end one... small hands help!!

Posted on Jan 07, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Front wheel bearing on suzuki 03 xl7 4x4

old post.
and axles , really?

$4 bucks to read the manual.
such a deal .

here is the GV , page. its same really

2001 + have the newer bearing hubs, unitized.

removing is easy, putting back right far harder.

see end hub #4
pull that with slide hammer, after removing screws #6
remove 7,8,9 and then using special tool pull ring 11.
with slide hammer pull, bearing hub.#1

RTM read the manual , at pitstop above
or the factory service manual , FSM
or at,

Dec 31, 2013 | 2003 Suzuki XL-7

1 Answer

Key got stuck in 99 Olds Intrigue. I cannot turn the car fully off (stuck on "accessory") and cannot turn the car back on either. The car is in park.

if it is a column shift try with your left hand reaching over the sterring wheel and pulling back or up to park position a little higher and with your right hand turning the key. don't know for sure but give it a shot

Feb 26, 2011 | 1999 Oldsmobile Intrigue

1 Answer

Where is the battery located

to get to the battery on most breezes you have to take off the front driver tire and the wheel well
You really do not have to take the wheel off just turn it all the way to the left and jack it up a few inches the battery will slide right out
To get to the battery on a 99 Breeze, turn the wheel as far as you can to the left. In front of the tire in the wheel-well is a plastic cover with 5 tabs across the top and side. Turn these 1/4 turn to the left, and the panel pulls off. Use a 1/2 inch socket to remove the battery mount/hold down. It would be best to remove the top bolt first. Then use a 5/16 inch socket to remove the front mount battery cables, and the battery will slide right out. You may have to lift the car a bit to get the battery out.

Feb 02, 2011 | 1999 Plymouth Breeze

2 Answers

How to replace a blower motor on a 99 oldsmobile cutlass

remove lower right dash insulator panal from beneath glove box. slide bcm aside to get to blower. remove the three screws holding the blower motor, pull blower and fan straight out. remove fan from old blower if replacing with a new motor. good-luck!!

Jul 17, 2010 | 1999 Oldsmobile Cutlass

1 Answer

Climate control display for Outside temperature

Had the same problem, replaced the ambient air temp sensor in front of the radiator. Cost is like 10-15 bucks. Don't worry if temp doesn't change right away. Took me about 5 miles and then it worked great.

Sep 13, 2009 | 1999 Oldsmobile Intrigue

2 Answers

How to 'bleed' the coolant in a 99 Olds Intrigue?

where the top radiator hose goes into the top of the engine is where the bleeder is up on top of where the hose goes in. mine is a copper like flathead screw looking thing ! fill the radiator and loosen the bleeder a little and wait for the coolant to start spraying a straight stream of coolant out of the bleeder! hope this helps!

Jul 07, 2009 | 1999 Oldsmobile Intrigue

1 Answer

99 Olds Intrigue outside temp stuck at 33°

Needs new ambient air sensor. Autozone has them. They go on front of vehicle near radiator. Easy fix.

Mar 17, 2009 | 1999 Oldsmobile Intrigue

2 Answers

Alternator in a 99 olds' intrigue

you have to pull the radiator to get the alternator out. had to do this couple months ago. then after you get it unbolted you need to slide it past exhaust and out toward the drivers side of car. pulling radiator was rediculous, but the only way!!!! hope that helps

Sep 30, 2008 | 1999 Oldsmobile Intrigue

Not finding what you are looking for?
1999 Oldsmobile Intrigue Logo

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides