Question about 2001 Toyota Celica

Open Question

My headlights on a 2001 Toyota Camry will stay on.

Headlights stay on after you turn off car & open drivers door. Some times you can shut them off with the key on & then turn the car off. Some times after a few minutes they may come back on. If you turn them on with the ignition switch off & then turn the head light switch off they stay on until you pull the headlight relay. Swaped relay with my other Toyota & the same thing happens.

Posted by on

6 Suggested Answers

  • 651 Answers

SOURCE: Headlights not working, fuses good...

there sounds like a deffinant short some where. you'll need someone that knows electrical to find the sourse. sorry

Posted on Dec 01, 2008

mrgreenz
  • 962 Answers

SOURCE: Lady with a 1999 4Runner cannot start car after...

Recharge the battery. Or buy a new one. But make sure you have a fully charged battery.What happened was that the battery drained because it probably needs replacement. When the battery drained too low. The ECU deprogramed itself. When installing a new or fully charged battery. Start the car. You may have to remove the negative cable a few times then restart it for the CPU to go into the default settings.

Posted on Dec 02, 2008

bad_dog1
  • 104 Answers

SOURCE: 97 camry headlights stay on

more than likely one of these is bad: 1. GAUGE Fuse (I/P J/B No.1)
2. Integration Relay (I/P J/B No.1)
3. Door Courtesy Switch (Driver’s)
4. Wire Harness

BE−14
BE−31

Posted on Dec 15, 2008

  • 1986 Answers

SOURCE: Headlight adjustment instructions

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams: Aim the headlight directly at the line you marked on the wall.

Posted on Sep 30, 2009

  • 507 Answers

SOURCE: 2006 Toyota Camry....headlights will not come on;

there was a recall on the headlight switch up to 06 camrys,find out if your car is affected by calling Toyota with the chassis no,and month of build

Posted on Nov 01, 2009

  • 1986 Answers

SOURCE: wear is the adjustment for the headlights on a

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Nov 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

5 Answers

I have a 97 toyota camry. the headlights stay on all the time.I've replaced relay and light switch on collun,still stays on any idea's


if they shut off when the car is on,then they are daytime running lights,if they stay on after the car is shut off and the light switch is turned off,then the switch is bad

Jun 12, 2015 | 1997 Toyota Camry

1 Answer

Lights will not turn on


HEADLIGHTS NOT WORKING


It can be faulty headlight switch or issue with its wiring. Or its faulty head light fuse.


==========

To troubleshoot the issue i suggest you few help links with appropriate solution. So you can follow the test and confirm what exact problem is there in your case of headlights not working:-----

Click the link below: -----


All headlights not working?

http://repairhelpcenter.blogspot.com/2012/01/all-headlights-not-working.html

----------

Working of Headlight switch?
------------
Both headlight bulbs blow together?

------------
Car headlight bulbs don't last long?

---------------

2007 Dodge Caliber: Low Beam Headlight Not working

http://technoanswers.blogspot.in/2012/06/2007-dodge-caliber-low-beam-headlight.html

----------

2003 Toyota Camry: Headlights Work Intermittently?

http://technoanswers.blogspot.in/2012/04/2003-toyota-camry-headlights-work.html

----------

Chevy Tahoe: Low Beam Lamps are not working?

http://technoanswers.blogspot.in/2012/04/chevy-tahoe-low-beam-lamps-are-not.html

----------

2001 Chevrolet Tahoe: Headlights not coming ON?

http://technoanswers.blogspot.in/2012/04/2001-chevrolet-tahoe-headlights-not.html

--------

2004 Dodge Ram: High Beam Light is DIM?

http://technoanswers.blogspot.in/2012/04/2004-dodge-ram-high-beam-light-is-dim.html

----------

2001 Chevrolet Tahoe: Both Low Beam Lamps Not Working?

http://technoanswers.blogspot.in/2012/04/2001-chevrolet-tahoe-both-low-beam.html

------------

Low beam headlights Modification?

http://schematicsdiagram.blogspot.in/2012/04/low-beam-headlights-modification.html

---------
How to Replace a Headlight

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-headlight.html

------------
How to Replace a Headlight Bulb


http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-headlight-bulb.html

-----------
How to Replace a Headlight Switch

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-headlight-switch.html

----------
How to Replace a Headlight Assembly

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-headlight-assembly.html


How to Replace a Park Light Assembly

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-park-light-assembly.html

-----------

Low beam headlights Modification?

http://schematicsdiagram.blogspot.in/2012/04/low-beam-headlights-modification.html

----------

Headlight Assembly Removal On Honda Accord

http://technoanswers.blogspot.in/2012/06/headlight-assembly-removal-on-honda.html

---------------

Honda Headlight Assembly Removal
http://schematicsdiagram.blogspot.in/2012/06/honda-headlight-assembly-removal.html

-----------

How to Replace a Headlight Door

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-headlight-door.html

----------

How to replace HID headlight bulbs for lexus 400h?

http://schematicsdiagram.blogspot.com/2012/01/how-to-replace-hid-headlight-bulbs-for.html

----------------

These will help.

Thanks.

Nov 28, 2012 | 1986 GMC K1500

1 Answer

Headlights do not go off so battery went dead. Also dome light does not respond to drivers door


Never rely on the door switch to shut off the lights.
That is always an extremely unreliable system on any car.
Whenever you shut a car off, turn off everything. That includes radio, AC, fan, etc. Otherwise you are putting a great strain on your battery when you next try to start it.

Jun 18, 2012 | 2001 Toyota 4Runner

2 Answers

Camry headlights not working


it sounds like a bad light switch

Mar 25, 2010 | 1993 Toyota Camry V6

1 Answer

How can I program the door locks on my 2002 Camry so they do not lock when you put the car in gear?


Put the key in the ignition, turn to the on position. Open the driver's door and remove the key (keep door open). Put the key in and out 4 times (in/ out only without any turning of the key) with the key out at the end. Hit drivers side unlock button 5 times. Wait at least ten seconds and shut the driver's door. Away you go. It will stay like this unless you remove the cars battery - if so you will have to do that sequence again. Works for most if not all toyotas

Jan 17, 2010 | 2002 Toyota Camry

1 Answer

2006 Toyota Camry....headlights will not come on;


there was a recall on the headlight switch up to 06 camrys,find out if your car is affected by calling Toyota with the chassis no,and month of build

Nov 01, 2009 | 2001 Toyota 4Runner

1 Answer

97 camry headlights stay on


more than likely one of these is bad: 1. GAUGE Fuse (I/P J/B No.1)
2. Integration Relay (I/P J/B No.1)
3. Door Courtesy Switch (Driver’s)
4. Wire Harness

BE−14
BE−31

Nov 21, 2008 | 2006 Toyota Corolla

Not finding what you are looking for?
2001 Toyota Celica Logo

Related Topics:

232 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...