Question about 1998 Ford Crown Victoria

Open Question

Location of Blower Motor Relay 2000 crown victoria

No power coming to my blower motor.

Posted by on

  • ginolena May 11, 2010

    is it automatic climate control or manual one?

×

6 Suggested Answers

emissionwiz
  • 61200 Answers

SOURCE: Blower motor location for 2000 Caravan

The motor is located just under the glove box on the passenger side. I remove the glove box then the panel below the glove box. I also go ahead and pull back the carpet and the padding under the motor. It is held in place by 3-4 bolts that take a 7-8 millimeter socket. I use a swivel extension for the back bolts. The motor with the fan blade attached is a tight fit, just keep wiggling and pulling it should come out. Try to remove the old moter without cracking the fan blade, because sometimes the replacement motor doesn't come with a blade

Posted on Sep 17, 2008

deathraider
  • 64 Answers

SOURCE: blower motor relay

there is not a relay , I had same problem and found out that its called a resister . the location is behind glove box , and to the left of the blower motor housing . look for a blue box with about 6 wires plugged into it . It has one screw holding it in , that the resister it is 39.99 @ auto zone and it will have to be ordered Please leave feed

Posted on Dec 02, 2008

97crownvic
  • 28 Answers

SOURCE: crown victoria window motor replacement

remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.

Posted on Mar 19, 2009

  • 24 Answers

SOURCE: 2001 Saturn L200 Sedan blower motor relay location

it's by the firewall pass side in the plastic blower box. Multi wire plug and two screws are showing.

Posted on Jul 22, 2009

  • 202 Answers

SOURCE: where is the blower motor relay on 95 accord

on the very top of the fuse/relay box in driver's side kick panel. on the very top of the fuse/relay box have 3 relay , the blowe motor relay is the center one.

Posted on Aug 08, 2009

co7196
  • 3433 Answers

SOURCE: 2002 Lincoln Town Car AC Blower Motor Relay Location

Relays are normally located under the hood in a protective plastic box. Good Luck Ned

Posted on Oct 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2004 crown vic. only 63K miles on her. AC/heat fan was sporadically working, now its done. AC was nice and cold, working fine. Is the fan a hard replacement if I were to find one at a parts yard?


Try to check the power and ground on the blower fan. If you missing the ground on the blower fan connector than most likely it is the blower fan resistor (controller), it is located under the hood close to back firewall behind left cylinder head.

Aug 17, 2015 | 2004 Ford Crown Victoria

1 Answer

Blower Motor on 2000 Saturn SL


The blower motor is connected to a termic switch, when the motor is fine and fuse is ok, is the switch that must be replaced.

Ensure the fuse is ok first.

Oct 02, 2008 | 2002 Ford Crown Victoria

1 Answer

2001 ford crown vic heater/ac fan switch doesn't blow anything at all on all speeds


you need to replace the blower resistor...90 percent of the time that will be the problem in your situation...before replacing it..check for power to blower motor first...if it has power then replace blower motor if not its the resistor

Nov 17, 2013 | 2000 Ford Crown Victoria

1 Answer

Blower on 2002 climate control only works on high


COULD BE BLOWER MOTOR RESISTOR OR BLOWER MOTOR CONTROL SWITCH IS FAULTY.

Jul 22, 2010 | 2004 Ford Crown Victoria

1 Answer

Where is the blower resister on a 2004 crown victoria


very unusual location. usually inside the car in the plenum case by passenger floor, but here it is:


Blower Motor Switch Resistor
The heater blower motor switch resistor has the following features:
  • The assembly is located in the engine compartment on the evaporator housing toward the center of the vehicle.
  • Three resistor elements are mounted on the resistor board to provide four blower motor speeds.
  • Depending on the heater blower motor switch position, series resistance is added or bypassed in the A/C blower motor circuit to decrease or increase A/C blower motor speed.
  • A device to prevent overheating (thermal limiter) will open the resistor coil when the temperature reaches 121°C (250°F) interrupting the blower motor operation in all speeds except HI.
  • The thermal limiter cannot be reset and is not serviceable.

Feb 19, 2010 | 2004 Ford Crown Victoria

1 Answer

Blower motor is go won't work at all ,switch is good on a 2001 crown victoria


check the blower relay also check the ground to the heater motor as well and use a jumper wire straight from the battery to the blower motor to make sure it isnt burnt out

Jan 20, 2010 | 2001 Ford Crown Victoria

1 Answer

2001 Crown vic LX Sport..Blower motor inop car has auto climate control. blower stopped then worked again then stopped again.


The blower motor might be bad,turn it on,high blower,and bump the blower motor body with the palm of your hand,if it starts to run,or tries to run,then replace the blower motor.

Jan 05, 2010 | 2001 Ford Crown Victoria

1 Answer

The A/C does not work. There is no fan, (a/c,


check fuse and relay first if good check switch if good check for power at blower motor if power motor may need service-lube- or replacement

Oct 23, 2009 | 1993 Ford Crown Victoria

2 Answers

Hvac blower not operating any speed,


have you tried replacing the blower resister module?

Sep 29, 2009 | 2003 Ford Crown Victoria

Not finding what you are looking for?
1998 Ford Crown Victoria Logo

Related Topics:

811 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...