99 Accord EX driver door window motor works but widow won't go up or down. Have taken off panel and think its regulator. To take out do i take out bolts that holding regulator and what about power wires for motor? Remove all bolts and pull window and regulator out and replace?
Pull off door panel speaker and switches. lower the window to where you see the two or four 10millimeter that connect scissor mechanism to the window. Prop window all the way up and put a door stopper to prevent the window from falling down. Unbolt window motor, unplug window motor, and unbolt eveything else in the door. Pull it all down and out through the bottom largest whole, lay flat on ground the entire indoor mechanism, out where you can see it on the floor. Take a pic with camera, and proceed to swapping regulator, intallation is same as removal. Good Luck
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Sounds like you have a problem with your window regulator. you need to unbolt the motor from the panel and take window off the regulator. I also have a 99 intrigue and my drivers side window did the same thing. The wire cords on the regulator where frayed and we replaced it. Found a new one of Autopartswarehouse.com for about $42 dollars with the motor.
not weird at all,you dont use ,so its jammed up.end of story ,remove door panel and give motor a light wack with something not to heavy whilst someone hold the switch in the up position with engine running to give an bit more voltage to window motor
If you here a click when you push the switch up or down, then it could be your window regulator (motor). To change remove door panel, there should be 3 bolts holding regulator to door frame and 2 bolts connecting regulator arm to window.
the motor is holding it in place you the only way to get it up if the motor itself is bad and you don't wanna replace it right now you can unbolt the window off the regulator and put the window up and jam it in place with something but the motor should be pretty easy to replace
possibly your power window regulator is out. basically check the fuses first to make sure you have not blown that, if it is good, then you can order a new window regulator from the dealer or online @ autopartswarehouse.com. to replace the window regulator you will need to will need to remove the door panel, start with the screws on the handle and the arm rest, covered with a plastic cap. the door panel which can be pryed from the bottom with a flat blade screw driver or flat pry bar, it will make a snapping sound. three bolts on the regulator 4 bolts on the window tracks and 2 bolts securing the window, re assemble as you have taken apart, Good Luck!!
I think you have a window regulator or a window motor problem. There are two wires a white one and a red one. You should remove the door panel the regulator and motor and check them. The plastic bushings in the motor has a tendency to disenegrate. If you remove the motor replace the bushings with ball bearings. $8.51 for three bushings vs $2.40 for barrings.
The regulator is your problem. The window must be in the regulator, properly aligned and securely fastened before it will go up and down. You said you have taken the door off. I assume you mean the door panel. If you have, look inside and you can see where the problem lies.