Question about 1992 Honda Accord

1 Answer

Removing headers on 1992 honda accod dx

How to remove header cap

Posted by on

  • mmpp20 May 11, 2010

    Are you trying to remove the exhaust manifold/heat shield and install a header?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Using a 13/16 wrench and some "rusty's Lube"

Posted on Dec 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have aftermarket headers on my 85 Monte Carlos my starter went out how would I remove the starter and taken out with the aftermarket headers in it there's no room to clear to bring it out


You will have to undo the exhaust at the collector flanges, then loosen of the header bolts/nuts but don't take them all the way out.
This should give you enough room to get the starter motor out as the headers should be able the swing out a little.

Oct 06, 2015 | Cars & Trucks

1 Answer

Putting in the antifreeze


remove header tank cap undo drain plug at bottom of radiator and bleed screw at top of radiator once all coolant has drained retighten tthe drain plug pour the new coolant into the header tank waiting for the coolant to drain through system and watch for coolant to come out of the bleed screw , shut bleed screw top up the header tank to the max level replace cap.Now run engine ,dont drive just stay with revs at 1500 open bleed screw to let any trapped air out and wait for the cooling fan to cut in , allow engine to cool down and refill header tank if required and repeat the running/bleeding/fancutting in procedure until when engine has cooled the coolant is near the max mark on header tank

Apr 09, 2014 | Fiat Palio Cars & Trucks

1 Answer

Header tank cap seperation


you have one of the faulty caps that were made you are going to need to replace it with a new one. you will need to prise out the bit stuck with a screw driver and lift it out if any parts brake off you need to take the coolant tank off and empty the broken bits/s out. caps are cheap to replace.. off ebay

Mar 09, 2014 | Vauxhall Cars & Trucks

1 Answer

Where do I find the engine fluid header 1992 Honda VFR750F


The radiator has a filling cap on the right side. Take off the right hand side cowl to have access to it.First fill the system through the radiator, with the bike on the side stand, all the way up, close the cap, run the engine for 10 minutes, then turn it off and let it cool down. Open the radiator's cap again and poor some additional fluid if needed.Then, beneath the radiator, is the expansion tank that you fill up to the max indication with the bike straight (not in side stand) on a leveled surface.

Feb 02, 2012 | Honda Cars & Trucks

1 Answer

My truck has a 360, and headers. there is a smog pump but i dont have all conections. i need a diagram


its an historic truck, put some historic tags on and forget about the smog pump , unless u want to remain stock and remove headers , but me personally i like headers , its better than stock look, get the ceramic headers with out emissions hook up , it will look awesome and u can remove smog pump.

Mar 27, 2011 | 1984 Dodge D150

1 Answer

,,i have a 97 civic needs a new clutch, what else besides the obviuos do i have to look out for in order to remove trans or should i go a another route, to replace clutch. i removed the spindle/ cv joint...


you have to unbolt the exhaust header and the two bolts under that, pull the radiator out so there is room to pull the exhaust header of the head,and let it drop down to get the two bolts out your talking about

Feb 18, 2010 | 1997 Honda Civic

1 Answer

I lost my manual and I need to know the radiator size of my 1992 Chevy K1500 5.7 truck


Specifications Core Size: 28-1/4 X 17-1/2 X 1-3/8 Inlet Header: 2-1/2 X 18-3/4 Outlet Header: 2-1/2 X 18-3/4 Inlet Connection: 1-5/16 DRIVERS SIDE Outlet Connection: 1-9/16 PASSENGERS SIDE

Sep 30, 2009 | 1992 Chevrolet K1500

1 Answer

1992 Chevrolet Suburban 1500 350 backfiring and headers glowing


You probably have a clogged up exhaust system building backpressure on the engine. Check your mufflers and catalytic convertors if you have them something is restricting the exhaust.

Sep 08, 2009 | Chevrolet Suburban 1500 Cars & Trucks

2 Answers

Where do i find the o2 sensor on a 2.0L 1992 accord manual?


most o2 sensors are located in the exhaust pipe at the cat con

Jun 04, 2009 | 1992 Honda Accord

Not finding what you are looking for?
1992 Honda Accord Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...