C class 240 driver car seat is not moving - 2003 Mercedes-Benz C-Class

no motor movement only

Hi, if its the complete seat check the runners beneath seat maybe sumtin in 1 of ridges, or if its the back of seat shake/rattle back and forth while holding button you know d sayig reoair by trial or error. Good luck

Just repaired that same problem on my the old ladys 2007 slk 280. Found flexible cable similar to that of a speedometer cable pulled out of end of seat motor. Feel around underneath seat towards back of seat for loose end of flex cable and simply slip it back in the slot at the end of motor

I believe that any 240 seat will fit. You actually want an older one. I think '89 or '90 was the year when they switched to lighter tubing. The '90 through '92 seat frames are nearly all tweaked, and sometimes crack.
If you don't buy new foam, try covering the foam with denim from old blue jeans, fastened on with spray on adhesive. That will keep it from crumbling on the seat springs.
http://www.frontiernet.net/~papi/Volvo_Seats.html

You may need to run the seat all the way forward then all the way backwards in order to resyncronize the seat. If that doesn't fix the problem then most likely the seat switch is faulty. I've seen this problem several times with the clk and the e-class.

In 2001 two c class
models 202 and 203
202 check fuse box in boot,spare wheel area
Fuses 12/13 25amp,these both control drivers seat
203 later c class
Check fuse box in boot, fuse 2 30amp,also fuse 38 30amp,located in fuse box end of dash

Hi there, it sounds like the fuel pumps have gone bad, they can be replaced by removing rear seat bottom cushion and removing metal cover and can be accesses on passenger side!
happy motoring!!

Can you hear the motor turn when trying to go back and forth? If not, motor may be faulty or bad relay in the wiring to that motor.
If you hear motor and seat doesn't move, then the motor may have fallen off track

The d.c.m module( your seat switch) controls the window operation and seat operation. It also relays signals to other control modules on the data system. does any other components not work? You can unplug certain connecter but not the main can connecter to the data bus. For the hell of it check the fuses. I beleive your schematic is located in the left side of the dash(behind plastic cover) visible when door is open. If not refer to owner's manual where the fuse schemstic is. good luck

Motor on the seat may have gone out, contacts in switch got dirty or worn, or assembly reached limit and stuck. Try sitting in it pushing back hard and adjust. If not youll need to replace switch,b take seat apart to fix or replace.