Question about 1999 Chrysler 300M

1 Answer

1999 Chrysler 300M, replaced battery

I now have no power in the cabin, everything is dead. When the battery was first connected there was power in the cabin, I turned the key and everything went dead. Is this a vehicle security problem?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 512 Answers

Check your battery connections and cables again. sounds like a loose connection

Posted on Jan 04, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Problem with 1999 Chrysler 300M My Chrysler 300m

If the engine doesn't turn over, it may be the solenoid not operating and not engaging the dog on the starter motor, if you get a healthy clunk when you turn the key but the engine does not turn, could be seized or there could be a transmission lock issue.

Oct 28, 2013 | Cars & Trucks

1 Answer

I have a 2001 Chrysler 300m and it sometimes won't start, when it doesn't start it also has absolutely no power. I popped the trunk to grab my cables and slammed it, the alarm reset and chirped and the car...

It sounds like u have a bad ground connection somewhere.I woud start with the battery and check all your wiring connections it could just be a loose connection somewhere.

Oct 06, 2013 | 1999 Chrysler 300M

1 Answer

I've been trying turn on my 1999 Chrysler 300m for

Check that the battery terminals and posts are shiny clean and tight. Have a load test done on the battery as it may be dead.

Sep 06, 2013 | Cars & Trucks

1 Answer

Removing shift linkage 300m

what linkage? the shift mechanism works with a cable; do you mean the shifter module in the cabin?

Mar 03, 2013 | 1999 Chrysler 300M

1 Answer

99 300M won't crank...

Bad Contact on battery terminals they may need cleaning and refit them , good luck .

Sep 29, 2017 | 1999 Chrysler 300M

1 Answer

Just put a new battery in my 1999 chrysler 300m and now when I try to start my car it just clicks,wut could b the possible issues,and also my brake lights will not shut off when the car is completly turned...

From your description of your problem it seems like your starter may be at fault. It may have a dead spot and the click you are hearing may be the starter solenoid engaging but not power is getting to the actual starter motor. As for the brake lights your brake light switch may have failed.

Mar 11, 2012 | 1999 Chrysler 300M

1 Answer

P1684 on my chrysler 300m pops up after 3 cranks but no start, what is the problem?

1684 "Battery has been disconnected within the last 50 starts"
Look for bad connections- Battery may be corroded, bad terminals both + and -.

Sep 21, 2011 | 1999 Chrysler 300M

1 Answer

Need to replace a idle air control valve on a 1999 300M Chrysler

Removal & Installation
  1. Disconnect the negative battery cable.
  2. Disconnect the IAC electrical connector.
  3. Remove the IAC mounting screws.
  4. Remove the IAC.


To install:
  1. Install the IAC to the throttle body.
  2. Tighten mounting screws to 5.1 Nm (45 inch lbs.) torque.
  3. Attach electrical connector to the IAC.
  4. Connect the negative battery cable.
  1. Disconnect electrical connector from IAC motor.
  2. Disconnect air plenum (where applicable).
  3. Remove two mounting bolts (screws).
  4. Remove IAC motor from throttle body.


To install:
  1. Install IAC motor to throttle body.
  2. Install and tighten two mounting bolts (screws) to 60 inch lbs. (7 Nm) torque.
  3. Install electrical connector.
  4. Connect air plenum (where applicable).

Mar 06, 2010 | 1999 Chrysler 300M

1 Answer

Anti-theft system seems to have been activated?

Some months ago I began starting the engine of my 2001 Chrysler 300M but turned it of before it really started "was sloppy with the key". The anti-theft system went on for some unknown reason. I disarmed it by disconnecting one of the battery connections under the hood with a wrench. I connected it again, the anti-theft system was off but the battery was dead. Battery was OK after recharging, I have had no trouble since then.

Jan 20, 2009 | 1999 Chrysler 300M

1 Answer

My 2001 300m wont start

Hi Yes for sure battery not got enough power or is poor connection at the battery but sounds like battery of the two.

Dec 11, 2008 | 2001 Chrysler 300M

Not finding what you are looking for?
1999 Chrysler 300M Logo

Related Topics:

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides