Question about 1991 Mercury Capri

1 Answer

Radio removal 1994 Mercury Capri I have an aftermarket sterio to install. What is the proceedure for removing the OEM radio ? Thanks, Dave

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Don't know if the info will be there but
All things Capri are at //
The manuals are there - check them out ...
Maybe radio removal is there ....

Posted on Jan 07, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I fix the clock display on my 1999 Pontiac Sunfire?

It appears to be that the radio clock display has malfunctioned, and is due for a replacement radio, which could be an aftermarket or oem radio, maybe found at a junk yard.

Tools required for oem replacement radio, torx keys set.

Before working on the radio or other electronics, disconnect the battery cables with 8mm wrench.

Replacing the oem radio is much easier, if you obtain oem radio, compared to aftermarket radio, due to being direct fit.

The radio is same for 1995 to 1999 Pontiac Sunfire and the Chevy Cavalier, regardless of sub models, such as SE,GT, VL,VLX,Z24. etc.

Parts needed for the the aftermarket radio install :Stereo assembly, stereo wiring harness adapter, radio antenna adapter, and dash install kit.wiring diagram for the wire colors / functions, along with tools, such as torx key set, screwdrivers,wire crimper, wire stripper, double ended wiring connectors, hair dryer.

The oem stereo removal video is for the 2000 to 2005 Sunfire / Cavalier, but are the same or very similar procedures.

Link to oem stereo removal procedures.
Pontiac Sunfire Radio Repair and Removal 2000 2005

Link to aftermarket stereo install / connect procedures. ( Sunfire Video )

Link to aftermarket stereo install / connect procedures. ( General Video )
How To Install Car Stereo Single Double DIN Car Audio 101

Have a nice day.

May 12, 2015 | 1999 Pontiac Sunfire

1 Answer

Is there a release switch to open the trunk of a 1994 capri?

No, key only. Sellers on ebay have aftermarket kits for about $25 if you want a switch...Chris

Oct 10, 2013 | 1994 Mercury Capri

1 Answer

Remove front bumper

You might find the information you need in the automotive section of your local library

May 10, 2013 | 1991 Mercury Capri

1 Answer

How do i replace the light switch that isn't the pull out to turn on type in a 1994 mercury capri

You need to remove the black plastic dash trim that the switch is in. There are several screws above the instrument cluster, and several behind the black trim pieces on either side of the steering wheel. Its a pretty easy job, those trim pieces just pry out, and snap back into place. Once loose. remove and replace the switch...good luck...Chris

Nov 07, 2011 | 1994 Mercury Capri

1 Answer

How to chang headlight lift motors on 1993 Mercury Capri

This applies to all 1991 to 1994 Capri

1. Raise headlamps to the normal operating position and open hood.
2. Remove the windshield washer reservoir or coolant reservoir, depending on which headlamp
assembly requires servicing.
3. Remove bezel and headlamp. Route wiring away from headlamp assembly.
4. Remove four screws and cover from headlamp assembly.
5. Remove four bolts retaining headlamp assembly to body.
6. Unplug connector from motor and remove headlamp assembly.
7. Remove nut retaining linkage to motor.
8. Remove three retaining bolts and motor.

If you have another motor, you can install it now and assemble in the reverse order. Make sure that when you put the linkage back on that it has the headlight in the raised position like before.

Your motor may not be bad just because it doesn't come up. If you take the 5 or so screws off the motor assembly, you'll see were some copper wipers make contact to a circular gear. Where they make contact could simply be dirty. Clean the gear with light sandpaper to get the copper on the gear shiny, then put it back together. You can test the motor now by plugging it back in and operate the may just work correctly...

Nov 02, 2010 | 1993 Mercury Capri

1 Answer

How do you remove the headlight from a 1991 mercury capri

take four screws out of housing (two on each side) slide housing toward front of car. remove two screws from crome ring and remove light. reverse to install

Sep 04, 2010 | 1991 Mercury Capri

4 Answers

1993 mercury capri the alternator belt keepsbreaking

you might be tightening it too tight or you have a burr on one of your pullies

Dec 10, 2009 | 1993 Mercury Capri

1 Answer

94 mercury capri bumper installation.

buy manual specific to vehicle

Sep 12, 2009 | 1994 Mercury Capri

1 Answer

Can't remove the lower control arm front bushing bolt

try to releive pressure by having it on stand also try another bolt from otherside or if you can get a vice grip on the shaft without stripping the threads and hit it with a hammer also wiggle control arm up and down while you do this

May 31, 2009 | 1994 Mercury Capri

Not finding what you are looking for?
1991 Mercury Capri Logo

Related Topics:

266 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

77499 Answers


Level 3 Expert

5608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides