SOURCE: 2000 jeep cherokee starts then stalls in approx 3 sec 4.0 has new crank sensor
I am going to assume that it will not run even if you push on the accelerator pedal?
Can you install or attach an old timing light to the spark plug wires, turn it one and try to start it. The light should flash with the engine running, but if it shuts off at time of engine die, and the engine is still spinning, you are losing spark, My suggestion is the cranks shaft sensor on bell housing.
Second, install a pressure gage on the test port on the fuel rail and watch it as you start the engine, fuel pressure should not drop as the engine dies, if it does, the pump is not working correctly. There are two modes of power to that pump, one to start and timed, for only a few seconds to prime the system, and one to run continuously. Find the wires going to the pump at the tank. Connect test light to those wires and watch what happens during crank and at stall, You should not have the pump shut off and the engine dies.
If you have spark, and fuel pump working, when did you last change the filter,,but I put that LAST.
It has to be one or the other of these.
Good Luck
SOURCE: 96 jeep grand cherokee 4.0
change the computer .... PCM get a used one it fixed mine had same problem
SOURCE: 2002 Jeep Grand Cherokee Lardo misfiring
You say you changed the cam sensor. A1391 code is a crank sensor on the top of the trans. bell housing.
SOURCE: 93 Jeep Grand Cherokee Won't start
The crankshaft position sensor was seriously problematic in those old jeeps. It's located towards the top of the bell housing slightly to the driver's side I think.
SOURCE: 95 jeep wrangler cranks but won't start. replaced
After you crank it for a while, take out one of the spark plugs. If it is dry then you have a fuel issue. If it is wet and smells like gas you have a spark issue. Find that out and report back and then we can get more specific.
184 views
Usually answered in minutes!
×