Question about 1991 Pontiac Bonneville

1 Answer

Blower motor i need to know how o get my blower motor out of my 91 bonneville PLEASE NEED HELP ITS COLD OUT

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I just recently had to do this myself, and thankfully its not too difficult. for ease of access start by removing the plastic cover that protects the fuses and relays in the engine compartment. next, using a 1/2" socket or wrench remove the two nuts that secure what seems to be a lift brace on the back of the engine.

with those two items out of the way diconnect the power from the blower motor. use a 9/32" wrench or socket to remove the 5 or 6 bolts that secure the motor to the firewall. with the bolts removed you may need to gently pry the rubber seal off of the firewall in order to remove the motor.

with the motor loose you should be able to spin and jimmy it around the tube that the tranmission dip stick resides in and remove it from the car. remove the rubber seal (and blower blades if necessary) from the old motor then follow the directions in reverse to install the new one.

Posted on Jan 20, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 98 bonneville se. the blower fan only comes on when the knob is all the way up and it ONLY blows heat and absolutely no cold also the air only blows out the defroster and the floor

How did you test the A/C system ? Hook up gauge manifold , test A/C pressures ? Manual or automatic climate control ? The blower motor only working on high means the blower motor resistor is bad ! Did you hook up a scan tool an check high an low pressure switchs inputs to the PCM - engine computer . Does the A/C compressor clutch engage ? turning on the compressor ? Moving the mode switch does nothing . Doesn't move from floor to vent to defrost ? Probably the mode door actuator ! Don't think the HVAC control panel is bad . Just a few little things . Pushing the A/C button on the control panel just send a electrical signal to the PCM , the PCM will energize the A/C clutch relay , turning on the compressor .

The Trainer 40 When the compressor won compress

Blower Motor Problems Auto Repair Help

Do you know how to test automotive electrical circuits ?

Heater Blower Motor Troubleshooting

May 19, 2017 | 1998 Pontiac Bonneville

1 Answer


Hey Brian, I did find every thing you need at auto zone library, its all free and no spam, just log in and list your vehicle then go to repair guides, then open repair help now go to chassis electrical . and look to left and click on blower motor .
hope this helps , good luck.

Feb 24, 2015 | 1996 Pontiac Bonneville SE CA Value

1 Answer

I have a 91 chevy s10 blazer and the heater/ac does not turn on at all, checked all fuses and changed blower motor....................NOTHING. My frustration level is mounting-help me please.

Trace the voltage. Is there voltage at the motor? If not trace it back through the resistor to the switch to the fuse. That will probably tell you what you need to know. Does it work on ANY blower speed setting? Replacing parts before testing is ALWAYS going to be frustrating.

Nov 24, 2013 | 1997 Chevrolet Blazer

1 Answer

I have a 91 toyota cressida the heat only blows hot when car is in motion what could be my problem please help its cold

Your blower motor may not be functioning. When you turn the interior fan on with the car at a standstill, then does it work?
Test for power to the unit. If power is present, then replace the blower motor.
If power is not present, then check the blower motor control switch (fan switch).

Nov 12, 2012 | Cars & Trucks

1 Answer

Can't get my blower motor out of my 1996 Bonneville

You will need to remove the engine's valve cover at the rear of engine to remove the blower motor, also replace the blower motor resistor while you are in there.

Oct 30, 2012 | 1996 Pontiac Bonneville SE CA Value

1 Answer

Why do my 91 buick park ave heater blow cold air?

you mean why doesnt it blow cold air most likey your blower motor is out and there is a litttle chip behind it call the blower motor resistor change that to if your gonna get a new blower motor

Sep 25, 2012 | 1991 Buick Park Avenue

1 Answer

How to replace a blower motor on a 2003 pontiac bonneville

Were is the blower motor located in a 04 bonneville and what would I need to replace it

Jun 25, 2012 | 2003 Pontiac Bonneville

2 Answers

Blower is making a roaring noise and sounds like

The noise is caused from a bad or dried up bearing. You will need to replace the whole blower motor

Jan 12, 2010 | 2003 Pontiac Bonneville

1 Answer

04 Bonneville, GXP. Blower Motor not Function Properly

sounds like the sensor is becoming questionable or a hi resistance ground in this part of the blower sensor circuit

Oct 05, 2009 | 2005 Pontiac Bonneville

1 Answer

1994 pontiac bonneville

it could be a fuse check the fuses if it aint a fuse most likely the blower motor

Jan 27, 2009 | 2001 Pontiac Bonneville

Not finding what you are looking for?
1991 Pontiac Bonneville Logo

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

83850 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides