Question about 2001 Saturn Lw 4dr Wagon

1 Answer

Car wont start

I know its not the battery i also replaced a switch

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Master
  • 416 Answers

Is it crunks but not start or it not even cranks.
If it first check spark plugs/wiring, distributor cap/rotor, colant temperature sensor. To figure it out first try to heat the car engine block with fan to see if it will affect anything. If no good check fuel lines too. If car won't crunk at all it can be starter or blown fuse.
For starter check the wiring comong to it, you can just move them a little, it might be just they are not tight enough. Let me know if you need more help
Good Luck

Posted on Dec 28, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2004 silverado ignition switch replaced now truck wont start

ignition switch ? Key & lock cylinder or the electrical switch ? Do you know how to test the ignition switch electrical circuit's using a volt meter ,hook up a professional scanner an check for module communications . Free wiring diagrams here . Did you get the switch installed correctly ?
How to Replace Your Ignition Switch in 2003 2006 GMC and Chevy truck and...

Jun 13, 2018 | Cars & Trucks

2 Answers

2005 f350 6.0 desiel wont crank. found broken clutch switch, replaced it still wont crank

Check for blown fuse under dash and under hood , make sure new switch is adjusted to the clutch pedal ,make sure the connecter to new switch is not damaged .

Mar 04, 2015 | 2005 Ford F 350 Super Duty

1 Answer

Idles wont rev

1998 ML320 - Switch OFF, Disconnect the neg battery cable for 2 minutes minimum. Reconnect battery with switch OFF. Then turn switch on and start engine. Should have relearned itself and work.

Mar 07, 2014 | Mercedes-Benz ML320 Cars & Trucks

1 Answer

My 94 Mazda Mx3 wont start...unless you push start it...power to everything but it wont turn over at noise...nothing. Thought it could be the clutch safety switch...NOT it. Anyone know?

sound like starter,have you can have starter checked out at any auto parts stores for free.replace both battery cables if they are old as vechicle bad battery cable will cause start problems. turn off radio first before removingnegative battery cable

Nov 16, 2011 | Cars & Trucks

2 Answers

Car wont start: 1. Had it tested technician sad

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

Click this link below and follow the troubleshooting:------


This will help.


Jun 23, 2010 | Cars & Trucks

2 Answers

Truck randomly won't start. No clicking, no nothing. Has a new battery, starter relay, ignition switch, etc. Someone told me to replace the clutch switch/neutral safety switch. I bought a neutral safety...

when it wont start, turn your headlights on, see if they work if they dont, find out why. When it wont start, take a wire from the positive battery terminal and touch it to the small post on the starter solenoid, it should crank. If it now cranks, theres a problem between the ign switch and the starter solenoid.

Jun 11, 2010 | 1984 Ford F 150

2 Answers

Car wont start

There are many reason why your car wont start.
Check Your Fuses
Battery Issue
Bad Igntion Switch
Bad Starter Connection
Test your ignition coil
Just go through these two link

Hope these links will help
Let me know
Kindly rate the answer

Jul 09, 2009 | 1999 Mercury Sable

1 Answer

98 jetta wont start with a good battery and good starter

A common plroblem on the 2.0 engine cars is the distributer, try changing that, if that doesnt work their is a sensor in the block right behind the oil filter than can cause the no start issue, but its not as common

Mar 17, 2009 | 1997 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts


Level 3 Expert

83850 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides