LEFT INDICATOR LAMP IS NOT LIGHTING ON DASH OR OUTSIDE CAR

ELECTRICS 101 (do you live in the RuST belt? ) wiki it.
first tell all electrics that work and do not (brief), and if engine runs and drives ok.???

all lamps inside and outside matter.
BLINKERS (TURNS) DEAD REAR. well that is bad wring on the rear.
(left rear and left front run off same wire) same is true

what did brake lamps do? BOTH DEAD AND THE 3LAMP TOO usa?
3 dead blinkers.
try a real ASE shop with tech and ASE badge on the sleeve.
the do now what to do,
all 10 + outside parking lamps work? 4 corners and sides.?
the cluster back ground lamps are on a dimmer it must be turned to high to see them. did kids play with dads car.? oops.
this year car like most that year, up have thing called BCM
the body brain I CALL, AND RUNS ALL LAMPS .
I WILL NOw RTM READ THE SERVICE MANUAL FOR YOU.
SO THE 4 SHOPS LOST THERE SCAN TOOL, that? ?????????
all fuses good, and scans show not one DTC error, i bet not.

let me begin at TURNS dead rear.(which one bad front NOT TOLD)
wow.
no hacked up added trailer hitch jack on car right, we look for that
after all fuses tested good (as in ALL)
do hazards work on all 4 corners, now that is so important on any car as huge clue #1
the T/sig fuse (ip box) is not blow due to front lamp 1 does flash.
the HAZARD fuse must be good or all 4 corners are dead.
now the turns. , the turn switch sends left to front and rear on 1 wire.
same with right.



see how front and rear use the same wire feed
so if rear fails you have bad (wrong lamps) or wiring bad.
for sure.
i bet hazards fail the same way. for the same reasons.



dash illuminations side is cluster fuse blown, in IP fuse box. dash
same box ROOM LP fuse
the dash brain, MICOM goes dead too, lacking both fuses good.

Replace left front fender - Fixya

www.fixya.com/cars/t26028082-replace_left_front_fender

Dec 29, 2015 - replace left front fender - Hyundai Motor 2003 Elantra question. ...Question about Hyundai Motor 2003 Elantra. Open Question ... How do i remove left front fender clip on a Lincoln ls 2002? Jan 04, 2015 ' 2002 Lincoln LS.

Replace 2003 hyundai elantra front passenger outside door ...

www.fixya.com/cars/t17348691-replace_2003_hyundai_elantra_front

Mar 26, 2013 - Question about Hyundai Motor 2003 Elantra. Open Question.Replace 2003 hyundai elantra front passenger outside door handle. Need to replacebroken exterior door handle on front passenger .... replace left front fender.

where are you, your key, in kitchen, standing near car, or in car or key inserted in the ignition, I will answer , IN KITCHEN.
the operators guide, lost>? it might the first clue.
http://justgivemethedamnmanual.com/hyundai/hyundai-tiburon-owners-manual/
the fob has a light. ok , Factory Fob, or aftermarket?

the car came with 2 fobs, new, so do both fail or act odd like this.
id bet not.
and the fob has and LED lamp , if it sticks on , that means'
the FOB is no good, the switches are stuck, ON.
time to buy a new FOB or get McGiver fix yours at x2 new cost.
you can also replace the battery and how that fixes it and or clean
the insides, of fob. at same time
page 1.5 above covers the fob.

the lamp flashes when the button is pressed.
so the button is stuck,, broken./

back light dead.
so use the dimmer knob. all cars have a dash dimmer that runs all car parking light on, dimmed lamps. all.
so fiddle that.
get the operators guide, (lost) ????
read the pages on dash dimming.
if that dont fix it, check fuses. next.

Yes, the grounding wires for the turn indicators get easily corroded - clean them.

The low beam is always on the outside, and the high beam is always closer to the grill...

No.. power is supplied to both bulbs in parallell... when power is present at one, it's also present at the other. Clarification needed - have you checked to see if you have power (battery voltage) and ground at the fog lamp connectors?.. if so, the problem is the bulb(s) it/them/self/selves. If you have an ohm meter or a test light, it's a simple procedure. Check the bulbs with an ohm meter. Then using a test light (12 volt, make sure the test light bulb is good by connecting it to a charges 12 v battery) connect the test light bulb to each of the fog lamp connectors with the fog lamp sw turned on and the ignition key in the 'run' position. If the test light illuminates at both fog lamp connectors, then the problem is in the fog lamp bulb(s) themselves. If not, there's a wiring/control circuit problem. You can go to http://www.hmaservice.com/ and register and gain access to lots and lots of technical info about your Sonata.

you should have the ESC/ABS module scanned for DTC's.

here are the 2 most likely causes.

1. low brake fluid
2. sticking/siezing brake lamp switch

at the dealership i see the brake lamp switches go bad left & right on a lot of the newer hyundai's. are your brake lights working?

The tiburon turn signals are controlled by a bcm (body control module) The bcm controls the ground to the signals. These always go bad and cause the signal to stick on or just not work. hope i was a help.

The SES lamp means there is a code in the ECM. Take to a pepboys or autozone, most of those places will check the code for free. Once you have the code, then we can diagnose the problem