Question about 1992 Jeep Wrangler

1 Answer

92 jeep wrangler, winter in chgo, will not allow push, trans?

Sluggish at start normal for weather, but tried several times to push in nuetral and wont budge. Did i blow the transmission? Any insight appreciated.

Posted by on

  • Richard Scordino May 11, 2010

    Stick shift? From what you said, sounds more like a blown differential, but need more info.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 33 Answers

I found in my jeep the parking brake likes to freeze on in cold weather other than that it sounds like it could be tranny transfercase or axels seized

Posted on Dec 29, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 92 jeep wrangler with a 4.0L 6cyl and it starts up but it idles very low. then after a little bit it idles normal and then back to a low idle again.


I suggest check your alternator with the voltage regulator eqpt or ensure the timing marks with regards to the timing belt are perfectly match base to the original manufacture/production...have a nice day!!

Jul 25, 2011 | 1992 Jeep Wrangler

1 Answer

I have a 1989 jeep Wrangler 4cyl.2.5l manual transmission . It does turn on good and it does shift into gear but it wont move at all ????


is the transfercase in nuetral ? check that as that is the only thing that could stop a manual trans from moving trk unless the output shaft in trans broke but that only you will know.

Apr 03, 2011 | 1989 Jeep Wrangler

1 Answer

1995 cherokee 4wd trouble starting must move gear shifter several times before it will start


try starting it in nuetral. if it starts everytime then the shifting switch is going out. If nothing changes then maybe the ignition switch is going bad and just by chance it starts by wiggling the shifter.
If this is a manual trans maybe the nuetral safety switch on the clutch pedal is going out.

Jan 12, 2010 | 1995 Jeep Cherokee

1 Answer

Crank, no start 98 wrangler 2.5l


crank sensor likely-may be distributor sensor but my 98 sport was crank sensor situated in bell housing timed by flywheel

Sep 15, 2009 | 1997 Jeep Wrangler

1 Answer

Jeep starts sluggish and then wants to die


It is most likely from that actually. You may need to adjust the air / fuel mixture after modding the intake. Sounds like its getting too much air.

Jul 17, 2009 | 1999 Jeep Wrangler

1 Answer

1997 Jeep Wrangler Door Lock Gets Stuck in Cold Weather


Shopping list: Spray can of "White Lithium grease" and a spray can of WD-40 or similar penetrating lubricant, and spray the door latch assy, inside out, with WD-40 first. Even if you have to put window down & aim spray nozzle from top at area of latch, and soak it. Stick the nozzle inside the key slot also, and give it a few squirts. After you let it sit for a minute or 2 start working the lock on door, lock ,unlock, lock, unlock, until you feel it getting easier, now do same with key, until it starts to loosen up. Once you get it working freely, give it a few minutes, and do same with "white lithium grease". That will hopefully protect it from seizing (rusting) up again. Every once in a while when you think of it, give latch another shot of lithium grease. I usually try to do mine before & after winter, or whenever I start to feel it getting a little stiff again. Worst thing is the glass you have to clean if you aim spray too much toward glass, but small price to pay for not having to pull door panel off. If your door panel is easy to get off to allow for better access to back of latch assy, that would definately be better, but that's up to you & your experience with tools. Then you can be sure you got all the related linkages lubed where they need to be.

Dec 23, 2008 | 1997 Jeep Wrangler

3 Answers

Jeep 4wd auto trans


Place the trans in nuetral then put the transfer case in 2HI.
when you drive on the road always have the transfer case in 2HI UNLESS you have a transfer case that has an alltime 4WD option

Jun 11, 2008 | 1987 Jeep Wrangler

Not finding what you are looking for?
1992 Jeep Wrangler Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

69244 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22026 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6817 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...